Dubia Roaches V2 36×18 Inch Deluxe Spacer Hood Instructions

June 22, 2024
Dubia Roaches

36″x18″ V2 Deluxe
Spacer Hood
Instructions
Updated: 05/08/2024

You must assemble this on a hard surface, this will not assemble correctly on carpet. When hammering all corners, try to make seams as tight as possible

V2 36×18 Inch Deluxe Spacer Hood

Step 1:
Remove film from all panels, on both sides. Including the black acrylic doors.

Step 2:
Get 1 (J) Long L-shaped Bar Single Track, (G) Long Logo Bar, 2 (E) Medium L- shaped Bar Single Track, and 4 (K) Corner Connectors. Ensure (G) logo is facing the front and hammer in parts as shown. Tracks should all be facing upwards, (K) should all have the openings on the floor, as shown in following photo.
Please double check that all (K) Corner Connectors have the opening facing the floor. These are not meant to come out once hammered in.

Step 3:
Get 2 (I) Short L-shaped Bars, Double Track. Ensure the double tracks line up in the front with the double tracks on the long logo bar. Hammer both (I) parts into the front corner connectors.

V2 models should have stickers that say This is the Front on the double track bars.
Step 4:
Get 2 (H) Short L-shaped Bars, Single Track. Hammer both (H) parts into the back corner connectors.

Step 5:
Get (F) Long L-shaped Bar Double Track (sticker says “Top Front”), 1 (J) Long Lshaped Bar Single Track, 2 (E) Medium L-shaped Bar Single Track, and 4 (K) Corner Connectors. Ensure (F) sticker is facing the front and hammer in parts as shown. Tracks should
all be facing upwards, (K) should all have the openings on the floor, as shown in following photo.

Step 6:
Take 2 (C) 24″ x 10″ Side Panels and place in each side frame slots as shown.

Step 7:
Take (A) Back Panel and slide into back frame slot as shown.

Step 8:
Take assembled top frame, be sure to line up double tracks in front with logo bar.
All channels in the front should be double channels. Once you are sure, hammer in all the corner connectors into the frame.

Step 9:
Assemble the door handles onto the (D) Black Acrylic Doors. You will use (L) Door Handle & Screws, (M) Door Handle White Washers, and (N) Door Handle Protector, Rubber. The order goes as shown:
-Door Handle Screw (DO NOT over tighten)
-White Washer (small end goes into the hole in the door)
-Door
-Rubber
-Handle

Step 10:
Get your assembled doors. With handles facing out, align one (D) Door (left door) in the back top track, press up, and place into back bottom track. Take the second (D) Door (right door) and place into front top track, press up, and place into front bottom track.

Step 11:
Place (Q) Stacker Pins into the holes in the corners of your enclosure as shown.

Step 12:
You can now place your Deluxe Spacer Hood on top of your enclosure. Be sure the (Q) Stacker Pins go into the bottom holes of the spacer hood. The (B) Support Bars are placed on top if you are stacking another enclosure on top. If you are not stacking an enclosure they are not necessary.

(P) Locking Pin is optional. It is installed as shown.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals