STAIRVILLE 485708 LB-3 Lighting Stand User Manual
- June 21, 2024
- STAIRVILLE
Table of Contents
LB-3
Lighting Stand
User Manual
General information
This document contains important instructions for the safe operation of the
product. Read and follow the safety instructions and all other instructions.
Keep the document for future refer‐ ence. Make sure that it is available to
all those using the product. If you sell the product to another user, be sure
that they also receive this document.
Our products and documentation are subject to a process of continuous
development. They are therefore subject to change. Please refer to the latest
version of the documentation, which is ready for download under
www.thomann.de.
1.1 Symbols and signal words
In this section you will find an overview of the meaning of symbols and signal
words that are used in this document.
Signal word | Meaning |
---|---|
DANGER! | This combination of symbol and signal word indicates an immediate |
dangerous situation that will result in death or serious injury if it is not
avoided.
WARNING!| This combination of symbol and signal word indicates a possible
dangerous situation that can result in death or serious injury if it is not
avoided.
CAUTION!| This combination of symbol and signal word indicates a possible
dangerous situation that can result in minor injury if it is not avoided.
NOTICE!| This combination of symbol and signal word indicates a possible
dangerous situation that can result in material and environmental damage if it
is not avoided.
Warning signs| Type of danger
| Warning – danger zone.
Safety instructions
Intended use
This light stand is intended to be used for the stable mounting and height-
adjustable positioning of spotlights. Use the device only as described in this
user manual. Any other use or use under other operating conditions is
considered to be improper and may result in personal injury or property
damage. No liability will be assumed for damages resulting from improper use.
This device may be used only by persons with sufficient physical, sensorial,
and intellectual abilities and having corresponding knowledge and experience.
Other persons may use this device only if they are supervised or instructed by
a person who is responsible for their safety.
Safety
DANGER!
Risk of injury and choking hazard for children!
Children can suffocate on packaging material and small parts. Children can
injure themselves when handling the product. Never allow children to play with
the packaging material and the product. Always store packaging material out of
the reach of babies and
small children. Always dispose of packaging material properly when it is not
in use. Never allow children to use the product without supervision. Keep
small parts away from children and make sure that the product does not shed
any small parts that children could play with.
CAUTION!
Risk of injury due to tipping of the stand during loaded transport!
If the stand is moved without having removed the installed devices, the stand
may tip over and cause injuries and property damage.
Remove the installed devices before transporting the stand.
CAUTION!
Risk of injury due to tipping of stand on an unsuitable ground!
When the stand is installed on soft or uneven ground, the stand may tip over
and cause injuries and property damage. Install the stand only on even and
solid ground.
CAUTION!
Risk of injury due to tipping of the stand from excessive loading!
In case of excessive loading, the stand might tip over, causing injury and
property damage. Never exceed the specified maximum load for the stand.
CAUTION!
Risk of injury due to tipping of the stand from excessive or one-sided loading
of the truss beam.
In case of excessive or one-sided loading of the truss beam the stand might
tip over, causing injury and property damage. Never exceed the specified
maximum load for the truss beam. Spread the weight of the mounted devices
evenly on the truss beam.
NOTICE!
Possible staining due to plasticiser in rubber feet!
The plasticiser contained in the rubber feet of this product may react with
the coating of the floor and cause permanent dark stains after some time. If
necessary, use a suitable mat or felt slide to prevent direct contact between
the device’s rubber feet and the floor.
Features
-
Complete lighting stand set consisting of
– 2 × truss
– 2 × lighting stand
– 2 × truss flange -
Suitable for mounting up to eight spotlights or effects
-
Extension tubes secured by safety screws
-
Truss tube diameter: 18 mm
-
Stand tube diameter: 28 mm
-
Maximum load capacity: 60 kg
-
Maximum height: 3.18 m
-
Width: 3.91 m
Installation
Unpack and check carefully there is no transportation damage before using the product. Keep the equipment packaging. To fully protect the product against vibration, dust and moisture during transportation or storage use the original packaging or your own packaging material suitable for transport or storage, respectively.
WARNING!
Risk of injury due to falling when mounting the truss or the spotlight!
Risk of injury due to falling or falling parts if using unsuitable climbing
aids when mounting the truss or the spotlights.
Always use a suitable working platform or a sturdy ladder for mounting a truss
or a spotlight.
Always place the working platform or the ladder on flat and stable ground.
Comply with regulations
When installing and operating, make sure to follow the standards and
regulations that apply in your country.
- Unfold the feet of the stands until the cross braces are in a horizontal position.
- Secure this position with the safety screw on the carriage to which the three feet are attached.
- Screw the two truss parts together with the three supplied hex screws and nuts.
- Insert the two truss holders into the extension tubes of the two stands and secure the adapter with the fastening screw.
- Attach the mounted truss beam and secure it in the required position with the wing nuts.
- Loosen the two safety screws on the extension tubes. Pull out the extension tubes of the two stands to the desired height and secure them with the help of the safety screw on the stand.
- Mount up to eight effects or spotlights to the truss beam and secure the devices additionally with a safety cable. Arrange the devices as symmetrically as possible. Observe the instructions of the respective manufacturers. The maximum total load capacity of
60 kg must not be exceeded.
⇒ The truss is assembled.
Technical specifications
Height, max. | 3.18 m |
---|---|
Total width | 3.91 m |
Adjustable stand height | 2.12 m … 3.18 m |
Footprint per stand | Ø 1.21 m |
Single truss length | 1.50 m |
Truss tube diameter | Ø18 mm |
Stand tube diameter | Ø 28 mm |
Mounting slots | 8 |
Mount type | 2 × truss flange |
Load, max. (with centric load) | 60 kg |
Transport dimensions (W × H × D) | 207 mm × 1,500 mm × 182 mm |
Weight | 22.5 kg |
Colour | item no. 485708 Black |
item no. 369941 Silver
Further information
Stand type | Background kit |
---|---|
Incl. truss beam | Yes |
Crank | No |
Protecting the environment
Disposal of the packing material
Environmentally friendly materials have been chosen for the packaging. These
materials can be sent for normal recycling. Ensure that plastic bags,
packaging, etc. are disposed of in the proper manner.
Do not dispose of these materials with your normal household waste, but make
sure that they are collected for recycling. Please follow the instructions and
markings on the packaging.
Observe the disposal note regarding documentation in France.
Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Telephone: +49 (0) 9546 9223-0
Internet: www.thomann.de
06.06.2024, ID: 485708, 369941 (V2)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>