ITC 21060-001 Color Module Installation Guide
- June 3, 2024
- ITC
Table of Contents
ITC 21060-001 Color Module
PARTS / TOOLS NEEDED
Safety Instructions
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Do not install any luminaire assembly closer than 6” from any combustible materials.
- Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current
DIMENSION
-
Determine the installation location for your color module. Make sure to consider the size of the module (3.2”L x 2”W x 0.8”H) when determining your location. Note, it will require room for access and for wiring. Once determined, clean the back of the module and the install location with alcohol wipes (not provided). Place the double stick pads (included) on the back of the module as shown below. Remove the paper and stick the module in place.
- Do not mount in area where water can be splashed over unit.
- Do not mount in area where water can be splashed over unit.
-
Follow the wiring diagram below to wire the module to your system.
For warranty information please visit www.itc-us.com/warranty-return- policy
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>