NISSAN 4361113 Lighting System Owner’s Manual

NISSAN LIGHTING System
Owner’s manual

4361113 Lighting System

© 2023 Voxx International Corporation. All rights reserved. This manual, or any portion thereof, may not be reproduced without the express written permission of Voxx International Corporation. Design and specifications are subject to change without notice

ACCENT LIGHTING REFRENCE GUIDE

Interior Accent Lighting (If only system equipped)

Switch Location

• The switch is located on the panel left of the steering wheel shown below.

Note: Adjustment of the lighting should be done while parked, not while moving to prevent distraction.

To turn On-Off Accent Lighting

• Press and hold button

Change Colors (20 Color Kits Only)

• Pressing the button will cycle through the 20 colors shown in Table 1

Table 1

Operation

With Ignition off the lights will illuminate to full intensity when doors is open, room lamp must be on, for the Interior Accent Lighting system to operate.

• While the vehicle’s ignition is started the accent lighting will dim.
• When vehicle is turned off Illumination will return to full intensity. Then turns off when vehicles room lamp turns off.

Panoramic Headliner Illumination (If only system equipped)

1. Switch Location
   • The switch is located on the panel left of the steering wheel shown below.

2. To turn On-Off Accent Lighting
   Press and hold button

3. Operation
   Lights will illuminate to full intensity when doors open, room lamp must be on, for the Panoramic Headliner Illumination system to operate.
   • While the vehicle’s ignition is Running the accent lighting will dim.
   • When vehicle is turned off Illumination will return to full intensity. Then turns off when vehicles room lamp turns off.

Interior Accent Lighting and Panoramic Headliner Illumination (If both systems are equipped)

1. Switch Location
   • The switch is located on the panel left of the steering wheel shown below.

2. To turn On/Off Interior Accent Lighting (System defaults to Interior Accent Lighting)
   • Press and hold button.

3. Change Colors (20 Color Kits Only)
   Pressing the button will cycle through the 20 colors shown in Table 1

4. To turn On/Off Panoramic Headliner Illumination
   • Press the button (This switches system to Panoramic Headliner Illumination)• Press and hold button button
   • Press the button again to switch back to Interior Accent Lighting control.

5. Operation
   Lights will illuminate to full intensity when doors open, room lamp must be on, for the Panoramic Headliner Illumination system to operate.
   • While the vehicle’s ignition is Running the accent lighting will dim.
   • When vehicle is turned off Illumination will return to full intensity. Then turns off when vehicles room lamp turns off.

FCC certification of this device refers to RF exposure testing under typical operating conditions, taking into account that this device can only be installed in designated vehicles.
To demonstrate compliance with RF exposure 2.1093- Portable category, it is acceptable for the passenger to be no more than 10 cm from the equipment surface and the driver no more than 11 cm from the equipment surface, according to KDB 951290 Section 3.3.
This device is certified as fully compliant with FCC Wireless Power
Transmission KDB 680106 requirements only under specified conditions.
The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 10 centimeters from the device surface at all times, except for nonrepetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.

Compliance Information

FCC ID: Z3K-4361113
IC: 9930A-4361113
FCC Notice
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause unacceptable interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.

• FCC Warning:
• To assure continued FCC compliance, the user must use the provided grounded power supply cord and the shielded video interface cable with bonded ferrite cores. Also, any unauthorized change or modifications to this device would void the user’s authority to operate this device.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Compliance Information
WEEE Notice
Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems)

This symbol on the product or on its packaging indicates that device shall not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this device is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this device. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this device, please contact your local city office, your household waste disposal service, or the shop where you purchased the device. Applicable accessory: remote control.

Macrovision Notice
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

All Information, specifications, and illustrations in this manual are those in effect at the time of printing. Nissan reserves the right to change specifications or design without notice and without obligation.
Nissan, the Nissan Bran Symbol, “SHIFT_” tagline, Z and Nissan models names are Nissan trademarks. 2007 Nissan North America, Inc.

This product is only intended for installation in: Brand ：NISSAN / Model ：KICKS

© 2023 VOXX International Corporation.
The company, product and service names used in this quick start guide are for identification purposes only. All trademarks and registered trademarks are the property of their respective owners and are not affiliated with or sponsored by VOXX International Corporation or its affiliates.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>