ANKER A7852M Wireless Vertical Ergonomic Mouse User Guide

QUICK START GUIDE
Wireless Vertical Ergonomic Mouse

At a Glance

1. scrott wheet

2. Left Button

3. Right Button

4. DPI Switch

5. Next Page Button (Not for Apple Mac 0S)

6. Previous Page Button (Not for Apple Mac OS)

7. Nano Receiver

8. DPI Switch: Press this button to switch between 800, 1200, and 1400 OP!.

9. Next Page Button: Press this button to go forward one page while web browsing.

10. Previous Page Sutton: Press this button to go back one page while web browsing.

Instructions

1. Remove the battery cover.
2. Insert 2 AAA batteries (not included) into the battery slot.
3. Remove the nano receiver and insert it into the computer’s USS port. The driver will automatically install.
4. Press the DPt switch to shift to the desired DPI level.

The indicator flashes continuously if the battery is low.

Specifications

Attention

| Don’t expose to liquids
---|---
| Don’t disassemble
| Avoid dropping
| Avold extreme temperatures

Troubleshooting

1. Make sure the nano receiver is plugged into your device’s USB port. If it is still unresponsive, plug the receiver into another USB port on your device.
2. Your mouse is not paired with the nano receiver. To pair: Turn on the mouse, plug the nano receiver into your device’s USB port. and then hold the scroll wheel and the right button of the mouse simultaneousty. Release the two buttons after 3 seconds to finish paring. If unsuccessful, unplug the receiver, turn off the mouse, and then repeat the above steps to restart pairing. Ouring pairing, make sure the mouse is close to the receiver.

Oectaration of Conformity

This product complies with the radio interference requirements of the European Community. Hereby, Anker Innovations Limited declares that the radio equipment type A7852M 1s in compliance with Directive 201 4/53/EU. The full text of the EU declaration of conformity 1s available at the following internet address: https://www.anker.com/products
Maximum output power. 546DBm
Frequency band: 2.4G band (2403~2479 MHz)
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich. Germany
Dectaration of Conformity
This product complies with the radio interference requirements ot the European Community. Hereby, Anker Innovations Limited declares that the radio equipment type A7850 = is in compliance with Directive 2014/53/EU. The full text of the EU declaration of contormuty ss avaiable at the following internet address: https://www.anker.com/products
Maximum output power: -655DBm
Frequency band: 2.4G band (2403.2479 Miz)
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich. Germany
GB Dectaration of Conformity
Hereby, Anker Innovations Limited deciares that the product type A7852M is in compliance with the Radio Equipment Regutations 2017 and the Restriction of the Use of Certain Hazardous Substances in Etectrical and Electronic
Equipment Regulations 2012. The fuil text of the G8 declaration of canformity is available at the following internet address: hitps://www.anker.com
Anker Technology (UK) Limited.
GNR&. 69 Clarendon Road, Watford, Hertfordshire, WD17 1HP. United Kingdom
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A7850 is im compliance with the Radio Equipment Regulations 2017 and the Restriction of the Use of Certain Hazardous Substances in Etectrical and Electronic
Equipment Regulations 2012. The fuil text of the G8 declaration of conformity is available at the following internet address: hitps://www.anker.com
Anker Technology (UK) Limited.
GNR8, 49 Clarendon Road. Watford. Hertfordshire, W017 THP. United Kingdom
Wireless Vertical Ergonomic Mouse
Modal NO:A7852M FCC ID 2AOKB-A7852M1 IC23491-A7852M — HVIN-A7852M1
IC NOTICE TO CANADIAN USERS
This device complies with Industry Canada license-exermpt RSS standardis).
Operation +s subject to the following two conditions: {1) This device may not cause interference, and (2} This device must accept any interference, inctuding interference that may cause undesired operation of the device. This device complies with RSS-210 of Industry Canada. Operation is subject to the cendition that this device does not cause harmful interference. This Ciass B digital apparatus complies with Canadian ICES-003.

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
   (1) Ths device may not cause harmful interference.
   (2) This device must accept any interference received, including interterence that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could vor the user’s authority to operate the equipment.
   NOTE: This equipment has been tested and found to comply with the limits for a Class 6 digital device. pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in 3 residential installation.
   This equipment generates uses and can radiate radio frequency energy and. not installed and used in accordance with the instructions, may cause harmful interterence to radio communications However, there is no guarantee that interference wilt not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one of more of the following measures:

• Reonent or relocate the recernng antenna.
• Increase the separation between the equipment and receiver.
• Connect the equiament into an outiet on a circunt different from that to which the receiver is connected
• Consult the dealer or an expemenced radio/TV technician for help.

Nano Receiver
Modal NOA7850 FOC ID 2A0KB-A7850R1 IC 23451-A7850R1 HVINA7850RI

IC NOTICE TO CANADIAN USERS
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference. and (2) This device must accept any interference, including interference that may cause undesired aperatian of the device. This device complies with RSS-210 of Industry Canada. Operation is subject to the condition that this device does not cause harmful interference. This Ciass B digital apparatus complies with Canadian ICES-003

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operatron is subject to the following two conditions:
   (1) This device may not cause harmful interference,
   (2) This dewce must accept any interference received. including interference thal may cause undesired operation

2. Changes or modifications not expressly approved by the party responsible tor compliance could voed the user’s authority to operate the equipment
   NOTE: This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to prowde reasonable protection against harmful interference mn 3 residential installation,
   This equipment generates uses and can radiate radeo frequency energy and. if not installed and used in accordance with the mstructions, may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation. tf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by ane or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to whoch the recerver is connected.
• Consult the deaier or an expenenced radia/ TY technician tor help.

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facitity for recycling. Follow local rutes and never dispose of the product and rechargeable battenes with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.
Wireless Vertical Ergonomic Mouse
Madel No. A7B52M
Nano Receiver
Model No.: A7850
Anker Innovations Limited
Room 1318-19, Hollywood Plaza. 610 Nathan Road. Mongkok. Kowloon, Hong Kong
The device has been evaluated to meet general RF exposure requirement.
Tha device can ba néad In porable exposure condition rdthont rectiction.

Customer service

| 18- month imited warranty
---|---
| Lifetime technical support
| support@anker.com
| (US) +1 (800) 988 7973 Mon-Fri 9:00 – 17:00 (PT)
(UK) +44 (0) 1604 936200 Mon-Fri 6:00 – 11:00 (GMT)

For FAQs and more information, please visit:

anker.com/support

| @Anker
@Anker Japan
@Anker Deutschland
---|---
| @AnkerOfficial
@Anker_JP
|  @Anker

A7852M/A7850
51005001119 V03

Documents / Resources

| ANKER A7852M Wireless Vertical Ergonomic Mouse [pdf] User Guide
A7852M Wireless Vertical Ergonomic Mouse, A7852M, Wireless Vertical Ergonomic Mouse, Vertical Ergonomic Mouse, Ergonomic Mouse, Mouse
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>