marchia MB36 Curved Glass Refrigerated Bakery Display Case User Manual
- June 21, 2024
- marchia
Table of Contents
CURVED GLASS REFRIGERATED
BAKERY DISPLAY CASE
USER MANUAL MODEL: MB36, MB48, MB60, MB36-B, MB48-B,
MB60-B, MB36-W, MB48-W, MB60-W
General
- Top brand fully enclosed compressor is used on the standing refrigerator. The refrigerant R290 is of an environmentally friendly agent. It features a rational configuration of refrigeration system with blower forced air cooling. The temperature is quite even inside the refrigerator.
- Triple hollow transparent glasses are used on door and body. It features an artistic and elegant appearance. perfect perspective and easy access.
- It has a wide application in department store and house as well as the meeting room and sitting room.
Structure and Parts
Handle and Erection
Handle with care
Unplug the wall socket first.
Never tilt it over 45 degree during handling.
Ory place
Always locate the refrigerator at a dry place.
Sufficient space
The distance from both sides and back of refrigerator to wall or other
substance must be More than 1 Ocm. The refrigeration capability might be
decreased if its surround space is too small to circulate air.
Well ventilation
Always locate the refrigerator at a place with fine ventilation. For the first
time use, wait for 2 hours after handling and then plug the wall socket and
start it.
Far from heat source
Never place the refrigerator directly under the sunshine. Never locate it
nearby any heat source or heater to prevent 1t from reducing refrigeration
capability
No heavy load
Never put any heavy load on the top of the refrigerator. No hole making Never
make hole on the refrigerator. Never install other matter on the refrigerator.
Stable location
Unpacking and locate the refrigerator on a flat and solid place.
Preparation and Power Supply
Exclusive power socket Normally. the power supply should be 115V,60Hz single
phase AC with exclusive single phase three pin receptacle. No share on socket
Never let the refrigerator share the common socket with other appliance, other
wise the cable becomes hot and fire might be resulted
Protect cables
Never break or damage the cables otherwise current leakage and fire might be
resulted.
No water flushing
Never giver the refrigerator surface a flush otherwise current leakage might
be resulted. Prevent from flammables and explosive Never put any flammable or
explosive inside the refrigerator such as ether, gasoline. alcohol. adhesive
and explosive. Never put dangerous product nearby the refrigerator.
No spray
To spray the flammables such as paint or coating nearby the refrigerator is
not allowed, otherwise fire might be resulted.
After power break
After power break or unplugging the refrigerator. always wait at least 5
minutes and then you may plug the refrigerator and start it again.
No medicine
No medicine is allowed to keep inside the refrigerator.
Use and Cautions
-
Before use:
Plug the refrigerator on. 11 0-120V ….. exclusive socket
After the refrigerator runnin9,put hand on the air suction to confirm H is sufficient cold. Then you may put food inside the cold box. -
Digital temperature controller
It is a mini-sized and integrated intelligent controller and applicable to the
compressor of one Hp.
The main functions are :Temperature Display/Temperature Control/Manual,
automatic defrost by turning off/lllumination Control/Value Storing /Self
Testing /Parameter Locking
Front panel operation
-
Set temperature
Press button, the set temperature is displayed.
Press or button to modify and store the displayed value.
Press button to exit the adjustment and display the cold-room temperature. -
If no more button is pressed within 10 seconds, the cold-room temperature will be displayed.
-
Illumination: Press button, it lights; Press again, it stops.
Manual start/stop defrost: Press button and hold for 6 seconds to defrost or stop defrost. -
Refrigerant LED: During refrigeration, the LED is on; When the cold room temp. is constant, the LED is off; During the delay start, the LED flashes.
-
Defrost LED: during defrosting, the LED is on; When is stops defrosting, the LED is off, During the delay display of defrost, the LED flashes.
-
Digital controller reset
When display shows “Disorder”, press “ ” button for 2s until buzzer rings, quickly press “ ” button for 6s until buzzer rings again, the display will flash for 3s and it restores factory setting.
Troubleshooting of digital control
Fault code | Causes | Solutions |
---|---|---|
EE I | open circuit or short circuit of temperature probe | Check lithe plug on |
mainboard is loosened or not, or change temp. probe;
EE2| open circuit or short circuit of defrosting probe| Check if the plug on
mainboard is loosened or not, or change defrosting probe;
EE 3| open circuit or short circuit of overheating probe| Check if the plug on
mainboard is loosened or not, or change overheating probe;
EE4| overheating probe starts protecting program 58r(136.47)| 1.Too much dust
on condenser(Clean the condenser)
2.Condenser motor stops working (Repair or change the motor)
3.The unit is too close to the wall. (Keep product away from the wall 50cm at
least)
4.Ambient temp. is too high. (Make sure ambient temp. stays within the range
as rating label specified.)
Cautions
Shorten the door open time and reduce open frequency is good to keep a cold
temperature inside the refrigerator.
Never block the air suction and outlet. Keep air circulation and refrigeration
capability.
Do not make food congested as it will influence the cooling effect.
Adjust the rack height for proper food storage.
Cool the hot food down to room temperature before you put it into the
refrigerator.
Try to reduce the open times and keep refrigerator inside cold in case the
power is cut off.
Only skilled service man is allowed to repair the damaged power cable with
special tools.
Never touch compressor to avoid from scald.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction conceding
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
The operation manual are not suitable for the persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge.
WARNING: Keep ventilation openings, in the appliance enclosure or in the
built-in structure, clear of obstruction.
WARNING: Do not use mechanical! devices of other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
WARNING: Do not damage the refrigerant circuit.
WARNING: Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type recommended by the
manufacturer.
ADDITIONAL WARNING
Caution: risk of fire. The height of the triangle in the symbol shall be
at least 1 Smm.
Maintenance
-
Notice
Often keep the refrigerator clean and periodical maintenance is necessary. Always unplug the socket before maintenance. Never use damaged plug or loose socket to prevent from electric shock or short circuit. Never flush the refrigerator. Never use alkali detergent, soap, gasoline, acetone or brush. -
Clean outside Dip soft cloth in neutral detergent(tableware detergent)to clean the outside of the refrigerator and then wipe it with dry soft cloth.
-
Clean inside Take rack out for cleaning with water. Use soft cloth to wipe the box.
-
Shut down refrigerator for a long time Take all food out and unplug the wail socket. Clean both inside and outside of the refrigerator thoroughly and open the door for sufficient dry. The glass breaks easily. Keep the glass far from children.
-
Replacement of lamp in the light box If the LED lamp is damaged, it must be replaced by the manufacturer, its service agent.
Trouble Shooting
Trouble | Cause and Remedy |
---|---|
No refrigeration | Is the plug in socket well? Is the fuse broken? |
Is there no power?
Unsatisfactory refrigeration| Is it under the sunshine? Is there any heat
source nearby? Is the surrounding ventilation bad?
Does the door close well9Does door open for a long time? Is the door seal
strip deformed or damaged?
Is food congested or too much?
Does food block the air suction or outlet?
Regulate the temperature controller.
Much noise| The refrigerator does not level.
The refrigerator contacts wall or other matter. There is loose pan in
refrigerator.
Contact local service agent for help if simple trouble shooting does not solve
the problems.
Following phenomena are not troubles The murmur of water is heard when the refrigerator is working. It is a normal phenomenon as the coolant is circulating in the system. In wet season, condensation might be found on the outside of the refrigerator. It is not a trouble, which is caused by high humidity. Simply use cloth to wipe it.
Principle of Refrigeration System
The principle of compression refrigeration consists of “compression” , “condensation” , “throttling” and “vaporization” . The compression is undertaken by compressor, the condensation is completed by condenser, the throttling valve is executed by capillary and the vaporization is implemented by evaporator. When the coolant is circulating in the closed refrigeration system, the compressor sucks coolant, which has absorbs heat in evaporator, the coolant becomes a high pressure and high temperature gas. In condenser, it dissipates heat in air, while the coolant is re-liquefied and throttled in capillary and then enters into evaporator with low pressure. The liquefied coolant quickly boils and vaporizes into gas when the pressure suddenly drops. Meanwhile, it absorbs heat inside the refrigerator. And the compressor sucks the low pressure and low temperature gaseous coolant,:—–:–.It is circulating in this way up to realization of intended refrigeration.
Circuit Diagram
Note
- The electric circuit diagram and parameters on the product nameplate are final ones if they have been changed.
- The design might be improved without notice.
Meaning of crossed out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities.
Contact you local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous
substances can leak into the groundwater and get into the food chain, damaging
your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated
to take back your old appliance for disposals at least free of charge.
USRESTAURANT® RESERVES THE RIGHT TO
CHANGE SPECIFICATIONS WITHOUT NOTICE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>