PREMIER COPPER PRODUCTS D-133BLK Bar Basket Strainer Drain Installation Guide
- June 20, 2024
- PREMIER COPPER PRODUCTS
Table of Contents
PREMIER COPPER PRODUCTS D-133BLK Bar Basket Strainer Drain
Specifications:
- Model: D-133BLK
- Type: 2 Bar Basket Strainer Drain
- Finish: Matte Black
Product Usage Instructions
-
Standard Installation:
-
Separate all mounting hardware as shown.
-
Apply plumber putty or silicone to the underside of the strainer body flange.
-
Place the strainer body into a sinkhole.
-
Place the rubber seal onto the top of the plastic tailpiece.
-
Place the tightening screw through the center of the top of the strainer body.
-
Holding the plastic tailpiece from below the sink, hand tightens the screw through the strainer body and into the plastic tailpiece.
Make sure that you tighten an additional 1/4 turn after hand tightening. -
Lubricate the post on the bottom of the strainer basket with liquid soap, then place the strainer basket into strainer body.
-
Attach the flanged drain pipe through nut and seal washer, then hand tightens the nut to the bottom of plastic tailpiece.
-
Protect with spray wax protectant (W900-WAX).
-
Care & Cleaning Instructions:
- Avoid using abrasive cleansers, S.O.S. Pads, or Scotch-Brite pads when cleaning your decorative drains.
FAQ:
- Q: Can I use this drain with a granite sink?
- A: Yes, the drain is suitable for use with granite sinks. Ensure proper installation for best results.
- Q: How often should I apply the spray wax protectant?
- A: It is recommended to apply the spray wax protectant periodically to maintain the finish of the drain.
TYPE: 2” Bar Basket Strainer Drain
FINISH : Matte Black
STANDARD INSTALLATION
-
Separate all mounting hardware as shown.
-
Apply plumbers putty or silicone to the underside of strainer body flange #3.
-
Place the strainer body #3 into sink hole.
-
Place rubber seal #4 onto the top of the plastic tailpiece #5.
-
Place tightening screw #2 through the center of the top of the strainer body #3.
-
Holding the plastic tailpiece #5 from below the sink, hand tighten the screw #2 through the strainer body #3 and into the plastic tailpiece #5.
Make sure that you tighten an additional 1/4 turn after hand tightened. -
Lubricate post on bottom of strainer basket #1 with liquid soap, then place strainer basket #1 into strainer body #3.
-
Attached flanged drain pipe (not shown) through nut #7 and seal washer #6, then hand tighten nut #7 to the bottom of plastic tailpiece #5.
-
Protect with spray wax protectant (W900-WAX).
CARE & CLEANING INSTRUCTIONS
- Do not use alkaline, acid based detergents, abrasive polishes, scouring cleansers, S.O.S. Pads or scotch brite pads when cleaning your decorative drains.
- Do not leave corrosive chemicals or solids laying in the bottom of the sink basin, such as coffee grounds, vinegar, etc.
- After normal use, always wipe the exposed surface area of your drain with a clean soft cloth. This will aid in limiting water spots.
- For normal cleaning, just wipe with a damp cloth and dry with a soft cloth.
- If a chemical cleaner is required when cleaning, windex or a mild dish washing soap can be used.
MORE INFORMATION
INFO@PREMIER-COPPER-PRODUCTS.COM | PREMIER-COPPER-PRODUCTS.COM
SUGGESTED ACCESSORIES
- W900-WAX
- Spray Wax Protectant
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>