AIGOSTAR SP.2835H120.01 LED High Voltage Light Strip User Manual

AIGOSTAR SP.2835H120.01 LED High Voltage Light Strip

SPECIFICATIONS

PACKAGE CONTAINS

COMPATIBLE ACCESSORIES

WARNINGS:

1. Please disconnect the power supply before installation. Do not cut, connect, or install the light strip while the power is on.
2. Be sure to cut the strip at the cut mark and install the end caps in time after cutting to avoid the risk of electric shock.
3. Before powering on the light, please spread the strip out; do not roll the strip on the reel and light it up or use it for more than 30 seconds.
4. Do not fold or twist the strip during installation; the maximum bending angle of the strip is 70 degrees, not 90 degrees.
5. The strip should be installed in a well-ventilated space with good heat dissipation, not on a flammable surface, and not wrap or cover the strip with any object.
6. Do not use this product if the strip or power cable is damaged.
7. Do not connect the light strip to other manufacturers’ light strip products.
8. Make sure all sealings are in place and sealed before use, and make sure to use the matching power cord and accessories for installation and use.
9. Only the strip part is 1P65, excluding the power supply. The connection between the power supply and the strip and the end caps need to be waterproofed before they can be used in outdoor environments.
10. The light source of the strip is not replaceable. When approaching the end of its service life, the luminaire must be replaced as a whole.
11. It is strictly forbidden to pull the strip and the power cable with a force of more than 60N, in order to prevent the main core wire from shifting and the lamp board from deforming after pulling.
    • This product contains a light source of energy efficiency class -(EU)2019/2015.

INSTALLATION STEPS

1. Do not power on the strip before installation.
2. Cut the strip according to the actual length of use. If it is necessary to cut the strip, please do so along the back of the strip with the cutting mark.
3. The newly cut end (without arrow markings) should be covered with an end cap and firmly glued.
4. Insert the pin of the power cable into the first end of the strip (marked with an arrow), making sure that the pin is in good contact with the strip pads
5. Apply glue evenly around the inner side of the front terminal of the output cable and insert the pin completely into the front terminal of the power cable in the direction of the arrow of the cable.
6. Secure the strip to the desired location using the fixing clips and screws.
7. Turn on the power and use it.

LIGHT SOURCE DISASSEMBLY DIAGRAM

• ITALIA MARKET SRL
• VIA DELLE INDUSTRIE, 9/1
• 20883 MEZZAGO(MB), ITALIA
• P.IVA: IT10502730962
• http://WWW.AIGOSTAR.COM
• MADE IN CHINA

Documents / Resources

| AIGOSTAR SP.2835H120.01 LED High Voltage Light Strip [pdf] User Manual
SP.2835H120.01 LED High Voltage Light Strip, SP.2835H120.01, LED High Voltage Light Strip, High Voltage Light Strip, Voltage Light Strip, Light Strip, Strip
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>