LECTRO VL-DAB Plus DAB Radio Owner’s Manual
- October 30, 2023
- LECTRO
Table of Contents
LECTRO VL-DAB Plus DAB Radio
Safety Information
Please read this manual thoroughly before using the product’ Keep it in hand
for future reference. Warnings alert the user to potential serious outcomes,
such as injury or adverse events to the user. Cautions alert the user to
exercise care necessary for the safe and effective use of the product. Notes
contain important information that may be overlooked or missed. This product
can be used indoors only (see below for more info).
This appliance may be used by children aged 12 and over, and by persons with
reduced physical, sensory or mental capacities or a lack of sufficient
experience and/or knowledge1 provided they are supervised or have been trained
in the safe use of the appliance and understand the potential dangers.
Cleaning and maintenance must not be carried out by children without
supervision. Children must not be allowed to play with the appliance.
Keep the packaging material away from children. There is a risk of
suffocation!
Do not allow unsupervised children to clean or maintain this device.
- WARNING! Do not leave packaging material lying around carelessly. This may become dangerous playing material for children. Risk ofsuffocation!
- DANGER due to swallowing small parts. Keep these away from children. Risk of suffocation!
Avoid danger to life by electric shock
-
Do not operate the unit with a damaged power line or damaged power plug.
ATTENTION’ Damaged power lines represent danger to life by electric shock. -
Check the power lines regularly for damages and aging. If the power line is da:rh:igec1 it must be re- placed f.:ythe manufacturer, hi½/ her representative or a similarly qualified person in order to avoid safety hazards.
-
Protect the power line against sharp edges, mechanical strain and hot surfaces.
-
Do not switch on the unit if you notice visible damages (e.g. tears or cracks) or if you assume that the unit is damaged (e.g. after having fallen down).
NOTE/WARNINGS
- Do not open the device yours-0 lf.
- This device is not a TOY, keer, a,,·a,- from children’
- Do not use with appliances that could cause any 7re in unattended use (like irons etc.).
- Any other use as the intended way forth,s device ,snot validated for any warranty or liability.
- I his device is only used for domestic and private use!
- Do r1ot use the device excessively and do not store them under heavy pressure. The device is not resistant to heat and water.
- Avoid rain, dampness or contact with other liquids
SPECIFICATIONS
Total watts·| 2 x 1,5 w RMS built-in Active Stereo with built in Bass
ReAex system
---|---
Impedance:| 40
Speaker driver frequency:| 100Hz-18KHZ, 53mm size Neodymium,
SNR:| e7odBA
Audio input mode:| DAB/DAB+/FM/Bluetooth/AUX / USB/TF
Preset stations:| 4ox DAB+/ 2ox FM radio
Battery capacity:| 37V@ 1800mAh
Playtime:| Up to 12 hours
LCD Screen:| With Backlight selectable
Built-in microphone·| Supported for handsfree calling
Equalizer mode:| Normal, Rock, Pop, Classic, Jazz, Rock, Speech, Flat, Movie,
News
Power input:| DC 5V e1ooomA (1A)
Working temperature:| o·C~+so·c
Dimens i ons:| 2oommx1oommx7omm
USB Power Input| Any 5V – 1A ~ 2A power device
Fast charge time:| 4H ± o sh (based on 2A input power)
Net weight:| About850 g
LED function:| Charge status, battery full indication
Bluetooth version:| V5.o
Bluetooth frequency:| 2A ~ 2,485 Ghz
Bluetooth range:
| +- 10 meters
Compatible with all Bluetooth A2DP Music devices in open space
OVERVIEW
FRONT SIDE
-
LCD Display
-
Remote Control Receiver
-
Speaker Driver
-
PU Leather Handle
TOPSIDE -
VOLUME KNOB
-
POWER ON/OFF/STANDBY
-
ALARM/CLOCK
-
PRESET RADIO STATIONS
-
INFO/MENU
-
MICROPHONE
-
PLAY/PAUSE/ENTER/SNOOZE
-
PREVIOUS/BACK/SKIP- (TRACKS)
-
NEXT/FORWARD/SKIP+ (TRACKS)
-
MODE/DISPLAY LIGHT
REAR SIDE -
RADIO TELESCOPIC ANTENNA
-
RESET BUTTON SWITCH
-
AUX AUDIO INPUT 3.SMM
-
LED CHARGE INDICATOR LIGHT
-
MICRO USB CHARGE PORT
-
MICRO SD/TF CARD SLOT
-
USB AUDIO INPUT PORT
REMOTE CONTROL DEVICE
Use a CR2025 3V battery for remote control1 positive side facing up. Please
take out the insulation tab plastic before using it!
If you need to replace the battery, take out the battery and push the battery
out from the side. The batteries can be removed easy.
Remote controllable distance is around 5-10 meters. It must be pointed to the
radio unit at all times.
RE-Battery assembly instructions
- Push the tab on the battery cover on the side and open the battery cover.
- Clean batte1v contacts and device contacts before installing the batte1\i
- Make sure to check the correct polarity+ and – inside the remote contrnl compartment.
- Put the battery cover back in place, and secure the buckle bv pressing It inside the remote housing.
NOTE
Remove the batteries ram the product 1f it is not used or a lrn,g time (1
mrn,th or longer) .
-
POWER ON/STANDBY
-
SCAN > When in DAB or FM Mode: Short press to scan radio station’ s
-
PRESET STATIONS> Long press number O -9 button to store the radio station, press O -9 button to select the radio station .
-
MENU> Press 1x for the menu setup settings
-
CLOCK> Press ix for the radio setup settings
-
INFO > Press 1x to show (different) info settings
-
SKIP – When in DAB+ or FM mode: Press 1x for previous radio station, press and hold to fast move the radio stations
When in BT mode: Press 1x for previous track When in MENU mode: Press 1x for previous step -
BACK> Press 1x to go back in the menu or settings.
When in alarm status long press to cancel the alarm sound. -
SNOOZE> When the alarm signal is activated, press 1x to go into the snooze status.
Press it again to select the desired snooze time . -
MUTE> Press 1x to activate ON/OFF
-
MODE/LIGHT> 1x Press to change DAB+/FM/BT/AUX mode change .
-
RESET 1x Press to show the radio station, Long press for the pre-stored radio stations .
-
ALARM> Press 1x for the alarm setup settings
(TIP: Press this button to switch off the alarm when activated.) -
VOLUME+
-
SKIP+
When in DAB+ or FM mode: Press 1x tor next radio station, press and hold to
tast move the radio stations.
When in BT mode: Press 1x for next track
When in MENU mode: Press 1x for next step -
ENTER> 1x Press to enter in DAB: :FM mode. 1x Press to pause in BT mode. 1x press to enter / confirm in the menu settings .
-
SLEEP > 1x Press to change the sleep mode into OFF/15/30/45/60/90 minutes .
-
VOLUME
-
LIGHT > Press to change the display light brightness (3x settings).
ALARM/CLOCK
When the device is powered ON ,tis in DAB mode and automatically searches for
DAB radio stations. If a DAB signal can be searched it will automatically set
the date and time using the lou,I DAB/DAB+ sig d When the time and date
settings are not set aLtomatically press and hold the ‘CLOCK’ button for
approximate Iv 2 seconds. Use the SKIP(TRACK buttons to set the time and date
and p,ess ‘ENTER’ to confirm ,t. To set the alarm in DAB+iFM mode press the ‘C
OCK’ button ix. Select the alarm setup number using the SKIP(TRACK buttons and
press ‘ENTER’. Use the SKIP/TR.C\CK buttuns to select your alarm times (up to
4pcs)i alarm durations, alarm s□ Uf’.C source, alarm calendar and press ENTER’
to confirm. ‘celect the alarm sound source using the SKIP!TRACK buttons and
press ‘ENTER’. Select the alarm calendar using the SKIP!TRACK buttons and
press ‘ENTER’. Select alarm ,•olume using the SKIP/TRC\CK buttons aw! press
‘ENTER’. Select alarm ,!uration using the SKIP/TRACK buttons and press
‘ENTER’. Use the ‘Sl,OOZE’ button to temporarily silence the alarm. TIP: Press
this button to switch off the alarm when activated.
PRESET RADIO STATIONS (DAB+/ FM mode)
To setup a pre-set radio station select the station of your cboice, using the
SKIP/TRACK controls, then press ‘ENTER’. Then press and hold the ‘PRESET’
button, use the SKIPiTR ,CK controls to find a free number, then press ‘ENTER’
to confirm. View the preset radio stations bv pressing the ‘PRESET’ button and
Lsing the SKIPiTR0.CK co·,trols to view all stations, press ‘ENTER’ to select
the station you like to fear.
INFO/MENU
To change the device and speaker settings in all mode’s (for example language,
time, scan, tune etc) press and hold the ‘INFO’ button to see the menu. Use
the SKIP/TRACK buttons to see and adjust all the settings in the menu and
press ‘ENTER’ to confirm.
To see the INFO press ,x in each mode to select the different info as desired.
MICROPHONE
This is a built-in microphone to use for handsfree calling.
PLAY/PAUSE/ENTER/SNOOZE
When use in DAB mode> Press ,x for enter, press approximately 2 seconds for
scan When use in FM mode> Press 1Xfor scan When in BT mode > Play/Pause the
music Use the ‘SNOOZE’ button to temporarily silence the alarm or select the
snooze time as desired.
PREVIOUS/SKIP-/BACK and NEXT/SKIP+/FORWARD
When in DAB+ or FM mode: Press ,x for previous/next radio station, press and
hold to fast move the radio stations
When in BT mode: Press ,x for previous/next track
When in MENU mode: Press ,x for previous/next step
MODE/LIGHT:
MODE DAB/ FM/ BT/ AUX>
Enter a mode by pressing the mode button until ‘DAB/FM/BT or AUX ‘is
displayed. Use the SKIP/TRACK buttons to select the previous/next radio
stations/music track or scan radio
stations and press ‘ENTER’ to confirm. When Bluetooth is selected it will
activate pairing mode automatically. Turn on Bluetooth on your mobile device
and select” Vlectro “from the list. You will then hear a sound that confirms
that you are “connected”. From now on you can listen to music and you are able
to receive calls. The device also supports incoming calls.
Note, The memory function is automatically supported when reconnecting both
devices that were used lasttime!
Bluetooth use:
-
Making phone calls
Make sure the device is connected to your mobile device. You can call now.
You answer the call by pressing the “ENTER” button once. To rejectthe call, long press the “ENTER” button so the call is rejected. You can change the volume by the volume knob or change it by the volume buttons from your device directly.
Note: all other functions should be used by your mobile device. -
Listen to your music
Make sure that the device is connected to your mobile device. You can now listen to the music on your playlist. ,x short press the” ENTER” button to stop the music. Press the button again
to continue. Press the SKIP+ – buttons for the next/ previous songs.
NOTE: When there is no music playing and no buttons have been pressed for 15 minutes, the device will automatically enter Standby mode.
Connect the 3.5mm Jack lead from your device to the AUX port if you want to listen wiredly from your (non Bluetooth) music source device. Connect a USB Flash Drive or connect a USB audio input cable and press the MODE button until you will see “USB” Insert a MICRO SD card into the rear of the radio speaker atthe SD/TF card slot and press the MODE button until you will see “SD”. Cards up till 32GB SDHC are supported. To adjust the LED display brightness, press and hold the ‘LIGHT’ button to select 1 ofthe 3 settings.
RADIO TELESCOPIC ANTENNA
When the signal is insufficient you can put it straight and make sure it is
extended for better
signal receptions. Near windows will improve the signal performance and
battery use time.
USB disk (or micro SD card) playback
Turn on, insert USB / micro SD card, then press the MDDE button to switch to
USB / SD mode.
It will play music from USB/ micro SD automatically. (Largest capacity of USB/
micro SD the device can support: 64GB SDHC)
Rotate the VOLUME knob to adjust volume, press the VOLUME key to mute sound.
Press the SKIP left and right key to switch between up and down songs, long
press the SKIP left and right key to rewind and fast forward. Press the ENTER
key to play or pause. During playback, short press the MENU-INFO key to view
the currently playing song information (current track/total track, current
playing time/total current track time, date, etc.) Supports audio decoding
formatMP3/WAV/FLAC/WMA/APE.
DECLARATION OF CONFORMITY
Confinity NV, Dorp 16, 9830, Sint-Martens-Latem, Belgium declares the
following device in sole responsibility:
Brand name: Vlectro
Product type: DAB+ radio
Item number: VL-DAB+
Complies with the following harmonization rules
EN 50663:2017
EN 624 79:2010
EN 62368-1:2014+A11:2017
EN 301 489-17 V3.2.4 (2020-09)
EN 301 489-1 V2.2.3 (2019-11)
EN 300 328 V2.2.2 (2019-07)
EN 303 345-1 V1 .1.1 (2019-06)
Draft EN 303 345-3 V1 .1.0 (2019-11)
Draft EN 303 345-4 V1 .1.0 (2019-11)
BS EN 55032:2015+A 11 :2020 BS
EN 55035:2017+A11:2020 BS
EN IEC 61000-3-2:2019BS
EN 61000-3-3:2013+A1:2019
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>