Instructions Sheet

2 or 3 Nautical Mile Port / Starboard / Stern Lamp
for: 2LT 017 460-xxx / 2LT 017 461-xxx / 2LT 017 462-xxx

Hella marine LED navigation lamps offer many advantages over conventional bulb lamps.

Significantly reduced power consumption, ultra long life and high tolerance to shock and vibration make the LED lamps the ideal choice for the harsh marine environment.

The Hella marine NaviLED® PRO series are precision optical instruments, tested and type approved to comply with international maritime regulations. They are covered by a 5 year warranty.

Dimensions

Electromagnetic Compatibility (EMC)

This LED lamp is an electronic device. The electrical circuits contain components that suppress possible interference, both emissions as well as susceptibility, to the limits prescribed in international regulations.

Protection against damage due to voltage spikes

This lamp is protected against reverse polarity connection, positive voltage spikes of +500 volts and negative voltage spikes of -500 volts.

Warranty Statement

Congratulations! The product you have selected comes from HELLA – one of the world’s leading manufacturers of lighting products. The product comes with a 5 year warranty from end user purchase covering faults in materials, components or workmanship.

In the unlikely event that you should experience a confirmed warranty related problem with your purchase, HELLA will, at its discretion, either repair, replace or refund the purchase price of the product.

Warranty services may be obtained by returning the product within the warranty period to the HELLA dealer where the product was originally purchased.

This warranty is in addition to and does not preclude any other rights or remedies available to the consumer under any local legislation related to the provision of goods or services.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.

You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

This warranty does not cover:

1. Claim/s as a result of normal wear and tear or of any modifications and / or alterations to the product in any shape or form.
2. Claim/s as a result of non-compliance of the assembly, service and operating instructions and/or any unfit or improper use.
3. Any expenses incurred in the process of making the claim.

Note: For lamps sold in Australia, warranty services are provided by Hella Australia Pty Ltd.,
4 Hargrave Place, Mentone, Victoria, 3194 Australia.
Customer Service 1800 061 729 email: custservice@hella.com
https://www.hella.com/hella- au/assets/media_global/IAM_Statement_of_Warranty.pdf
For general comments about Hella marine products please email techfeedback@hellamarine.com

NaviLED® PRO Integrated Timer

To ensure long term safety, this NaviLED® PRO lamp is equipped with a timing circuit.

Once the lamp has operated for a total time of 25,000 hours, the lamp activates ‘Service Mode’.

Service Mode is indicated by the lamp flashing at a rate of 60 flashes per minute for 15 seconds as soon as the lamp is switched on. This will occur for 15 seconds every time the lamp is switched on until the unit has operated for a further 2000 hours.

After this additional 2000 hours the Service Mode flash rate doubles to 120 flashes per minute for 15 seconds as soon as the lamp is switched on.

To ensure the lamp meets the light output criteria of its certification, Hella marine recommends the lamp be replaced as soon as it enters this 2000 hours Service Mode stage. By normal recreational boating standards, even with regular night sailing, Service Mode will hardly ever be reached.

Designed and Manufactured in New Zealand

Lamp positioning

General recommendations:

The signal arrow should point

• Right ahead for port / starboard lamps
• Right astern for stern lamps.

When the lamp is operating, the light should not be obstructed or concealed by superstructures or other objects.

Port and Starboard lamps:

Parallel to the vessel’s center line (see Fig.1)
and in a vertical position (see Fig.2).

Fig. 1 Position in relation to the vessel centre line

Must be mounted in the same thwart ships position and at the same height above the construction water line, but at least 1 metre lower than the masthead lamp. Lamps should mark the effective beam of the vessel; if this is not possible, the distance between the side lamps should not be less than 85% of the maximum beam of the vessel.

Stern lamps:

At right angles to the vessel’s center line (see Fig. 1) and in a vertical position (see Fig.2).

Fig. 2 Mount in vertical position

Assembly

Step 1 – Make provision for the power cable

Use mounting shroud as a template to drill screw holes and make provision for the cable.

Step 2 – Mount the Shroud

1. Shroud must be installed with markings on the top horizontal surface.
2. Arrow on top of shroud must point straight ahead.
3. Fix shroud with two M5 or 10 gauge fasteners.

Step 3 – Insert the optic assembly

Note: Arrow on top of shroud and arrow on top of optic assembly must point in the same direction.

1. Feed power cable through shroud
2. Push optic assembly into shroud
3. Connect power

Removal

Step 1

Carefully insert 2 screw drivers between optic assembly and shroud.

Step 2

Pull optic assembly out.

Note: Do not open. No serviceable parts inside.

Note: Do not open. No servicable parts inside.

http://www.hellamarine.com/

Documents / Resources

| Hella marine NaviLED PRO Starboard Navigation Lamp [pdf] Instruction Manual
NaviLED PRO, NaviLED PRO Starboard Navigation Lamp, Starboard Navigation Lamp, Navigation Lamp, Lamp
---|---

References

• Hella marine - Hella Marine

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>