Newland FM550 IVD Scanners User Guide

: June 13, 2024
: Newland

Table of Contents

Newland FM550 IVD Scanners
Product Information
Product Usage Instructions
Frequently Asked Questions
Laser safety warning
Appearance
Installation
External interface
Tinned wire
Programming barcodes
Maintenance and repair/FCC
WEEE/More information
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Newland FM550 IVD Scanners

Product Information

Product Specifications:

Type: Red Laser
Wavelength: 650nm
Pulse Width: 3ms
Classification: Class 1
Output: < 1.0 mW

Product Usage Instructions

Laser Safety:
Ensure to follow laser safety guidelines and do not look directly into the laser beam.

Wire Color Codes:

Red: VVC
Green: RS232_TX
White: RS232_RX
Purple: GND
Black: SW OUT
Orange: SW IN
Brown: USB_D-
Blue: USB_D+
Black (thick): FE

I/O Functions:

P: 5V Power Supply
O: RS-232 Output
I: RS-232 Input
P: Power Supply Ground
O: IO Output
I: IO Input
I/O: USB D Differential Data Signal
I/O: USB D+ Differential Data Signal
P: Shield

For more information, visit our website at newland-id.com

Frequently Asked Questions

Q: Is this product safe to use indoors?

A: Yes, this product is safe for indoor use when following proper safety precautions.

Q: Can the pulse width be adjusted?

A: No, the pulse width is fixed at 3ms for this product.

Q: What is the maximum power output of the laser?

A: The maximum power output of the laser is less than 1.0 mW.

Laser safety warning

Warning!
Please follow the regulations below, otherwise, it may lead to a hazard to the eyes and skin.

The FMSSO is a class 1 laser device.
Do not stare into beams.
Be aware of positioning such that a laser is not at risk of entering the eyes of any personnel, either directly or via reflections.
The laser aimer is intended for initial device positioning. Disable once positioning is completed.

Appearance

Installation

Side view

Note:

By default, the laser aiming function is turned off.
The laser aiming function is intended for initial device positioning and should be turned off upon completion of installation.
Additional information can be found in the user guide.

Test Tube Rack Application/Top view

External interface

Tinned wire

Programming barcodes

Laser aiming mode:
When the device enters this mode, the scanner will scan continuously in 100 scan sessions, each session separated by a flash of the illumination. After each session, a percentage read rate will be transmitted to the host as a prefix to the scanned data.

The FM550 will automatically enter continuous mode within 3 seconds of applying power, allowing initial configuration via programming codes. At this time, the laser aimer is off.

Maintenance and repair/FCC

Caution!

Protect the scan window from abrasion and contamination.
If the scan window needs to be cleaned, use a clean, lint-free cloth and commercially available window cleaner.
There are no user-serviceable parts within this product.
Upon encountering faults, please refer to Newland technical support and service for repair and advice.

Radiofrequency interface requirements Radio transmitters (part 15)
This device complies with part 15 of FCC standards concerning RF compatibility and susceptibility

Tested to comply with FCC Standards
FOR HOME OR OFFICE USE

Marking and European Economic Area (EEA)

Statement of Compliance
We hereby declare that this device is compliant with the mandatory requirements and provisions under Directive 2014/53/EU, EN 62471:2008 IEC 60825-1:2014, EN 60825-1:2014+A11:2021, EN 50689:2021