CORSTON Harper Fixed Mortice Door Handle Instruction Manual
- June 11, 2024
- CORSTON
Table of Contents
CORSTON Harper Fixed Mortice Door Handle Instruction Manual
Contents
-
Handles
-
Wood Screws
-
M4 Through Bolts
-
Roses
-
Thread Lock
-
Grub Screws
-
Fixed Spindles
Tools you’ll need
-
Drill
-
Cross head Screw Driver
-
8mm Drill Bit
-
2mm Drill Bit
-
Pliers
Installation Instruction
-
Mark the centre lines and hole spacing on both sides the door. Make sure the they are vertically flipped on each side.
-
Drill holes through the door for the through bolts with the 8mm drill bit
-
Drill pilot holes for the wood screws with the 2mm bit
-
Clip snap off screws to size so that they are smaller than the depth of the door
-
Screw the fixed spindles to the door with the through bolts
-
Drive the wood screws in to the door
-
Screw the roses and the handles on to the Fixed Spindle
-
8 If after screwing the handle on there is a gap bigger than a 1mm between the handle and rose, use the washer to fill the gap
-
Replace the grub screw in the handle with the grub screws with per-applied thread lock.
-
Screw the grub screw in to the handle and make it it is level
-
Wait 45mins for the thread lock to fully set
45 mins
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>