PINARELLO BOLIDE F HR Olimpic Extention Bar User Manual
- June 12, 2024
- PINARELLO
Table of Contents
PINARELLO BOLIDE F HR Olimpic Extention Bar User Manual
1. SIZE CHART
UCI RULES – CLASS MAX REACH – SIZE 310
These measurements were obtained with the bicycle in a horizontal position, with extensions inclined at 20° and at maximum extension. To obtain the final reach measurement, all the changes explained below that may have been made starting from this standard configuration must be added. All these measures do not include any commands or handcaps.
UCI RULES – CLASS MAX REACH – SIZE 285
These measurements were obtained with the bicycle in a horizontal position, with extensions inclined at 20° and at maximum extension. To obtain the final reach measurement, all the changes explained below that may have been made starting from this standard configuration must be added. All these measures do not include any commands or handcaps.
EXTENSION SLOPE ADJUSTMENT – SIZE 310
Rotation of the extensions between 10° and 30° with defined intervals of 5° is allowed. Changing the inclination causes a change in the total reach.
EXTENSION SLOPE ADJUSTMENT – SIZE 285
Rotation of the extensions between 10° and 30° with defined intervals of 5° is allowed. Changing the inclination causes a change in the total reach.
EXTENSION SLIDER ADJUSTMENT
Continuous translation of the extensions is allowed up to a maximum of 25mm. The difference in reach gained based on the inclination of the extensions is negligible.
HANDGRIP CUT ADJUSTMENT
The handrips can be shortened up to the minimum mark located 20mm from the tip. The maximum reduction involves a shortening of the reach by 10mm.
UCI RULES – CLASS MAX DROP
These results were obtained with the original handgrip. All these measures do not include any commands or handcaps. The table is valid for sizes 310 and 285.
ARMREST POSITION ADJUSTMENT
The position of the pads can vary along the direction of development of the extensions in steps of 11.25mm up to a maximum of 67.5mm between the two limit positions.
EXTENSION WIDTH ADJUSTMENT
The convergence angle of the extensions is defined as 5°. The width of the extensions varies with 25mm steps given by the holes on the basebar.
MIDDLE POINT OF THE PADS REACH AND STACK (upper face of the pads)
Starting point with inclination adjuster and 5 mm shaped spacer.
Variation of the Stack value depending on the version of handlebar used and width of the extensions.
It is possible to add a maximum number of spacers to increase the Stack equal to +45 mm and change the shaped spacer to gain +15 mm. The change in inclination partially contributes to varying both the Reach and Stack values of the pad.
2. ASSEMBLY INSTRUCTIONS
Perform the assembly by following the four steps outlined below.
WARNING
Use the best combination of washers and screws provided to engage the thread
as much as possible. Once this step is completed, visually check before
proceeding: the holes threaded parts must not be empty and the screws must not
protrude.
OLYMPIC EXTENSION BAR – PASSAGGIO CAVI Di2
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>