mooas MBS5R Portable Wireless Speaker User Manual

June 9, 2024
mooas

mooas MBS5R Portable Wireless Speaker

INTRODUCTION

Thank you for purchasing the new Portable Wireless Speaker B25W. Please read this manual carefully before operating your product and pay close attention to the precautions, which are mentioned below.

USING

  1. Long press the “ ” button to power on the Bluetooth speaker.
  2. The default mode is the playing mode when the last time power off.

Attention: The speaker has two modes: Speaker mode and Clock mode, Short press the” ” button to switch Clock and Speaker mode. Clock mode only shows the clock, can not play music.

  1. Short press the “ ” button to enter the clock setting, and “number” flashes. Turn right or turn left the “Volume Knob” to adjust the hour and minute, short press the” ” button to switch the hour and minute, and short press the “ ” or “▶ II/M ” button to confirm the hour and minute.

Note: Time is 24H.

  1. Confirm the device is in Clock mode.

  2. Short press the”▶II/M” button to set standby time (00-90 minutes). For example: If you set 10 minutes, the speaker will enter into standby after 10 minutes in any mode.

  3. Long press the” ” button to enter into the setting, “ ” icon and “number” flashing, turn the “Volume Knob” to adjust the hour and minute, short press the” ” button to switch the hour and minute, turn on/off the alarm, alarm parameters, ring count, alarm tone modes, short press “ ” button to confirm.

  4. The alarm on/off: “on” means alarm on; “off” means alarm off.

  5. Ring count: “one” means alarm only one time; “all” means alarm every day.

  6. Alarm tone modes:
    “bU” means alarm with the tone from the speaker system; “Sd” means alarm with the latest playing song of the TF card (should keep the TF card into speaker if select this tone). “Fn” means alarm with the latest playing FM radio.

  7. When all is set, the alarm is set.

  8. When the clock alarms, short press the” ” button to cancel the clock alarm. Or short press the other 3 buttons to set snooze time with intervals of 9 minutes.

  9. Confirm the device is in Speaker mode.

  10. Bluetooth speaker will automatically enter pairing mode, “BT” icon flashing.

  11. Search for “MOOAS MBS5” on the pairing device as a mobile phone and then connect.

  12. Enter password “0000” if required

  13. Double click “▶ II/M ” button to connect or disconnect Bluetooth

  14. Turn the “Volume Knob” to adjust the suitable volume.

  15. Short press the “▶ II/M ” button to play and pause the music.

  16. Short press the” ” or “ ” button to select the previous or next song

  • When a call in coming, short press the”▶ II/M ” button to answer the call, during the calling, short press it again to end the call.
  • When a call in coming, long press the “▶ II/M ” button to reject the call directly.
  • Confirm the device is in Speaker mode.
  • Long press the “▶II/M” button to AUX mode, the “AUX” icon flashing, connect the AUX cable to the aux-in port of the speaker, and connect the other end to the audio-out port of your external music device.
  • Turn right or turn left the “Volume Knob” to adjust the suitable volume.
  • Short press the “▶ II/M ” button be in silence.
  • Confirm the device is in Speaker mode.
  • Long press the “▶ II/M” button to TF mode, the “TF” icon flashing, and insert a Micro SD card.
  • Short press the “▶ II/M ” button to play and pause the music.
  • Short press the” ” or “ ” button to select the previous or next song.
  • Long press the” ” or “ ” button to fast backward or forward the song
  • Confirm the device is in Speaker mode.
  • Long press the “▶ II/M” button to FM mode, “FM” icon flashing
  • Short press the “▶ II/M ” button to automatically search and save valid stations,
  • Short press to next the station number. short press to the previous station.
  • Because the strength of the FM signal carries from a different place, please plug in an Aux cable as an antenna so that the FM signal could be better.
  • Before wireless charging, make sure the used phone support wireless charging.
  • Plug-in Type C fast charging cable to use the PD/QCC power for charging.*
  • Input : 5V2A/9V2A Out put :5W/10W
  • Put the phone on the speaker top section of “WIRELESS CHARGING” to charge.
  • Please fully charge the battery before using the device for the first time.
  • Connect the 5V 2A USB cable to the unit and the other end to AC adapter or PC in order to commence charging. The Red LED will turn on indicating that the unit is now charging. Once the light goes off, this means that the units are completely charged and ready to use.

SPECIFICATION

  • Bluetooth version: V5.0
  • FM Frequency: 76-108 MHZ
  • Speaker size: 57mm
  • RMS Power: 1 x 5W
  • SNR : ≥80dB
  • Distortion: ≤1%
  • Frequency Response: 80HZ-20KHZ
  • Battery: 3.7V/1200mAh lithium battery
  • Operating Temperature Range: -10º-50º
  • Playtime: 3-5Hours (depending on volume level)
  • Charging time: 2-3 hours
  • Product Size: 1528478mm
  • Weight: 520g
  • 1pc B25W Bluetooth speaker
  • 1pc 80cm 5V 2A charging cable
  • 1pc 80cm Aux in cable
  • 1pc User Manuel

Add 4th Floor, Building D, Huafeng No.1 Technology Park, Sanwei Xixiang, Baoan , Shenzhen,
Guangdong 518102, China.
Web: www.ihold.cc

FCC STATEMENT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals