mooas MWCS9 Flip Square 3 in 1 High Speed Wireless Charging Mood Lamp User Manual
- July 12, 2024
- mooas
Table of Contents
mooas MWCS9 Flip Square 3 in 1 High Speed Wireless Charging Mood Lamp User
Manual
Flip Square
3-in-1 High-Speed wireless charging Mood Lamp (Compatible with Apple Watch,
Galaxy watch)
MWCS9
1. Product Introduction
This product is 3 in 1 wireless charger that simultaneously charge the phone,
earphone and watch that support the QI standard. It is with LED Night Light
design, it is convenient and intelligent device
It is with a folding design, which makes it easy to store and carry.
You can charge your phone, earphone and watch in the correct charging area, which is really nice to use.
2. Specification Parameters
3. Operation Steps
- When use the wireless charger, first use a PD/QC3.0 adapter and Type-C cable to charge it.
- For the LED Night Light, first touch the switch button, it will show Low brightness (default), then touch again, it will show High brightness, then touch again, it will Light off.
- When charge the phone, earphone and watch, just put the device on the product charging area, then it will start charging. And you can take away when the devices finished charging
4. The phone can be placed horizontally/vertically to charge (like below photos).
5. The product can be folded for easy storage and portability.
4. Precations
-
Do not immerse the product in water to avoid short circuit of the internal circuit.
-
Do not disassemble or break the product by yourself, so as not to cause product damage. Please keep the product away from flammable and explosive liquids, gases or
explosives. -
Do not place magnetic cards, magnetic strip media and precision machinery too close to the product.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for comp iance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfu interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>