ARROW BMW R Nine T Scrambler Instruction Manual
- June 3, 2024
- Arrow
Table of Contents
ARROW BMW R Nine T Scrambler Instruction
PRELIMINARY INFORMATIONS FOR INSTALLATION **USE, WARRANTY AND
MAINTENANCE**
Limitations of warranty – general instructions
- During and after installation, be sure that the exhaust system is not touching any components sensible to high temperatures. Manufacturer is not liable for damages (including personal damage and injuries) of any kind resulting from improper use and installation of the exhaust system.
- After installation it is recommended to check all screws to be properly tightened and to check alignment of the exhaust system.
- When tightening original screws please follow the indications given in vehicle’s maintenance manual, for hardware given in the fitting kit please follow the values listed below:
- Warranty is limited to defects recognized by manufacturer’s technical service and related to normal use of the exhaust system. Warranty terms exclude components subject to normal wear, like gaskets and wadding materials. Warranty is void in case of accident, modifications, improper use and competition use.
- It is strongly recommended not to install and use the exhaust system on a vehicle for which the exhaust system has not been designed for.
- In normal use condition the exhaust system can get very hot, even when the engine is switched off. be careful to avoid contact with exhaust system surfaces.
- Wadding materials durability changes depending on the kind of use of the exhaust system. Generally and as a pure information, it is recommended to check internal wadding material every 8000/9000km and at least once a year or in case you notice a change in noise from the exhaust or a change in colour of silencer’s external body surface.
- Technical characteristics and specifications of Arrow exhaust systems and related components can be subject to modifications and changes without notice.
screw size | tightening torque| screw size|
tightening torque
---|---|---|---
M5| 5,5 Nm| M10| 42 Nm
M6| 9,5 Nm| M12 (sonda)| 24 Nm
M8| 21 Nm| M18 (sonda)| 28 Nm
FIITTIING IINSTRUCTIIONS
- Loosen the clamp, remove the screw securing the original silencer and remove the silencer
- Fit the clamp as shown above
- Fit the link pipe and secure the spring (do NOT tighten in this phase)
- Fit X-Kone silencer, secure the mount to the inner side of the mount and secure the spring
- Fit Pro-Race silencer, secure the mount to the external side of the mount (use the ø46mm washer given in the fitting kit on the inner side of the mount) and secure the spring
- Tighten the clamp
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>