OPTICON OPN-4000 Quick Start Guide
- June 8, 2024
- OPTICON
Table of Contents
QUICK START GUIDE
OPN-4000, GETTING STARTED
1D CCD, Feedback LED, Trigger Key, Feedback Buzzer,
Clear/Function Key, USB Connector (Data/Charging)
BLUETOOTH MODE
HID (Keyboard emulation)
SPP
Mfi (Only for the OPN-4000i)
USB MODE HID USB VCP
DISABLE ENABLE
RESET SCANNER SETTINGS
BUZZER
DISABLE ENABLE
BLUETOOTH PIN CODE – SET 0000
OPTICON
QUICK START INSTRUCTIONS
0
1
2
3
4
5
6
7
8
9
End
STEP 1- SCAN BLUETOOTH MODE
Scan the Bluetooth Default barcode that matches the connection method you wish
to use. The recommended mode is HID which is keyboard emulation. On iOS
devices, HID allows the on-screen keyboard to be toggled with the OPN-4000’s
function key. The other modes are SPP and MFi which is serial port emulation
and will require an application on the target device. MFi is only available on
the OPN-4000i
STEP 2 – HOLD THE FUNCTION KEY FOR 5 SEC
Hold the OPN-4000’s function key for 5 seconds until it beeps and begins to
flash blue. The OPN-4000 is now discoverable by your host device. This can be
cancelled at any time by holding the function key for another 5 sec.
STEP 3 – PERFORM BLUETOOTH SEARCH ON HOST
Use the Bluetooth interface on your host device to search for and select the
OPN-4000. The OPN-4000 will beep to indicate success or failure. If you are
pairing in Bluetooth-SPP or Apple MFi mode, the OPN-4000 will complete the
pairing process as soon as you launch an appropriate application (i.e. OPNTerm
for iDevices) and open the serial port created by your Bluetooth software. If
your host device does not support Simple Pairing, then you may use the
barcodes at left to input a PIN code. For information about your OPN-4000,
including detailed setup instructions, downloads and more, visit us at:
www.opticonusa.com/start/opn or www.opticon.com/service-and-support.aspx
OPTICON OPN-4000 Quick Start Guide – Download
[optimized]
OPTICON OPN-4000 Quick Start Guide – Download