ARROW NORDEN 901 Sonora Slip-On Exhaust Husqvarna Installation Guide
- June 3, 2024
- Arrow
Table of Contents
ARROW NORDEN 901 Sonora Slip-On Exhaust Husqvarna Installation Guide
PRELIMINARY INFORMATIONS FOR INSTALLATION, USE, WARRANTY AND MAINTENANCE.
LIMITATIONS OF WARRANTY. GENERAL INSTRUCTIONS.
- During and after installation, be sure that the exhaust system is not touching any components sensible to high temperatures. Manufacturer is not liable for damages (including personal damage and injuries) of any kind resulting from improper use and installation of the exhaust system.
- After installation it is recommended to check all screws to be properly tightened and to check alignment of the exhaust system.
- When tightening original screws please follow the indications given in vehicle’s maintenance manual, for hardware given in the fitting kit please follow the values listed.
- Warranty is limited to defects recognized by manufacturer’s technical service and related to normal use of the exhaust system. Warranty terms exclude components subject to normal wear, like gaskets and wadding materials. Warranty is void in case of accident, modifications, improper use and competition use.
- It is strongly recommended not to install and use the exhaust system on a vehicle for which the exhaust system has not been designed for.
- In normal use condition the exhaust system can get very hot, even when the engine is switched off. be careful to avoid contact with exhaust system surfaces.
- Wadding materials durability changes depending on the kind of use of the exhaust system. Generally and as a pure information, it is recommended to check internal wadding material every 8000/9000km and at least once a year or in case you notice a change in noise from the exhaust or a change in colour of silencer’s external body surface.
- Technical characteristics and specifications of Arrow exhaust systems and related components can be subject to modifications and changes without notice.
| SCREW SIZE | TIGHTENING TORQUE |
|---|---|
| M5 | 5,5 Nm |
| M6 | 9,5 Nm |
| M8 | 21 Nm |
| M10 | 42 Nm |
| M12 (SONDA) | 24 Nm |
| M18 (SONDA) | 28 Nm |
NOTICE ABOUT SOUND AND EMISSION LEVELS.
GENERAL NOTICE
Arrow distribute its products worldwide through the network of authorized distributors. Arrow Special Parts does not guarantee that its products are universally compliant with laws on polluting and noise emissions and relating to product identification. Buyers are responsible for complying with the laws and informing themselves about those in force in the place where they intend to use the products.
NOTICE FOR THE UNITED STATES
Some states in the United States and the US federal government have specific
laws governing the use of the aftermarket exhaust system, especially when its
assembly modifies, removes or replaces the stock catalyst.
We recommend that you consult the laws regarding pollutant and noise emissions
in force in the area before installing an aftermarket exhaust system to ensure
compliance with the laws in force.
Arrow Special Parts does not warrant that its products are universally
compliant with these laws.
CALIFORNIA NOTICE
California law prohibits the use of any aftermarket component or exhaust
system that modifies, removes or replaces the original catalyst. Use is
permitted only if the CARB (California Air Resources Board) has issued an
executive order for such components or exhaust systems or if they are
installed on a racing vehicle used in closed circuits.
Arrow Special Parts does not warrant that its exhaust systems are part of this
executive order or that they comply with the racing vehicle exemption.
Buyers are responsible for complying with the laws and informing themselves
about those in force in the place where they intend to use the products.
-
Remove the clamp, remove the screw securing the original silencer and remove the silencer.
-
Check that the gasket is properly placed in its seat.
-
Fit the silencer, secure the clamp and the welded mount.
-
Fit the caged nuts as shown above.
-
Fit the cover and fix the sticker.
