DJI Drone Arm Bracers User Guide
- June 7, 2024
- DJi
Table of Contents
Drone Arm Bracers
User Guide
v1.0 2021.01
Watch the tutorial video from the link below. make sure you fully understand the video before use.
Disclaimer and Warning
Please read this entire document and all safe and lawful practices DJI™
provided carefully before use. Failure to read and follow instructions and
warnings may result in serious injury to yourself or others, damage to your
DJI product, or damage to other objects in the vicinity. By using this
product, you hereby signify that you have read this disclaimer and warning
carefully and that you understand and agree to abide by the terms and
conditions herein. You agree that you are solely responsible for your own
conduct while using this product, and for any consequences thereof. DJI
accepts no liability for damage, injury, or any legal responsibility incurred
directly or indirectly from the use of this product.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as “DJI”) and
its affiliated companies. Names of products, brands, etc., appearing in this
document are trademarks or registered trademarks of their respective owner
companies. This product and document are copyrighted by DJI with all rights
reserved. No part of this product or document shall be reproduced in any form
without the prior written consent or authorization of DJI.
This document and all other collateral documents are subject to change at the
sole discretion of DJI. For up-to-date product information, visit
http://www.dji.com and click on the product page for this product.
This disclaimer is available in various languages. In the event of divergence
among different versions, the English version shall prevail.
Introduction
The DJI FPV Drone Arm Bracers are used to increase the strength of the aircraft arms and reduce damage to the aircraft in the event of a collision. It is recommended to use the arm bracers when there are many obstacles around.
Installation
- Check the mark on the bottom of the arm bracer and insert the arm bracer marked L from underneath the frame arms on the left side. Make sure the arm bracer forms a complete guard around the frame arms.
- Check the mark on the connector for the arm bracer and insert the clamp on the connector marked L into the groove at the end of the arm bracer. After aligning the screw holes, tighten the screw from the bottom.
- Repeat the steps above to install the arm bracer on the right side. The arm bracer and connector are marked R.
Specifications
Weight (one side): 19.5 g
DJI is a trademark of DJI.
Copyright © 2021 DJI All Rights Reserved.
Printed in China.
37QDDJAR01TY
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>