tp-link Next-Gen Tri-Band Gaming Router Installation Guide

tp-link Next-Gen Tri-Band Gaming Router

Before You Start

Turn off your modem, if any, and remove the backup battery if it has one.

Hold the antennas from the base and push them fully into the slots.

Connect the Hardware

If your internet connection is through an Ethernet cable directly from the wall instead of through a DSL / Cable / Satellite modem, connect the Ethernet cable to the router’s 2.5 Giga WAN port, and then follow steps 3 and 4 to complete the hardware connection.

Configure the Router

Method ONE: Via TP-Link Tether App

1. Download the Tether app.
   

2. Tap the + button in the Tether app and select Archer AX11000. Follow the steps to complete the setup and connect to the internet.
   

Enjoy the internet!

To enjoy more complete service from TP-Link register and bind your TP-Link ID to the router.

Method TWO: Via a Web Browser

1. Connect your device to the router wirelessly or with an Ethernet cable.
   The default wireless network names (SSIDs) and password are printed on the label at the bottom of the router
   

2. Launch a web browser, and enter http://tplinkwifi.net or http://192.168.0.1 in the address bar. Create a password to log in.
   Note: If the login window does not appear, please refer to Q1 of Need Help? in this guide.
   

3. Follow the step-by-step instructions to set up the internet connection and register for the TP-Link Cloud service.

LED & Button Explanation

Need Help?

Q1. What should I do if I can’t access the web management page?

• If the computer is set to a static IP, change its settings to obtain an IP address automatically.
  Verify that http://tplinkwifi.net is correctly entered in the web browser. Alternatively, enter http://192.168.0.1 or http://192.168.1.1 in the web browser.

• Use another web browser and try again.

• Reboot your router and try again.

• Disable and enable the network adapter in use.

Q2. What should I do if I can’t access the internet?

• Check if the internet is working normally by connecting a computer directly to the modem via an Ethernet cable. If it is not, contact your internet service provider.
• Log in to the web management page of the router, and go to Advanced > Network > Status to check whether the internet IP address is valid or not. If it is, please run the Quick Setup again; otherwise, check the hardware connection.
• Reboot your router and try again.
• For cable modem users, log in to the web management page of the router and go to Advanced > Network > Internet > MAC **Clone. Select Clone Current Device MAC and click SAVE.**
  Then reboot both the modem and the router.

Q3. What should I do if the router can’t be found via Bluetooth in Tether (how to reset the router)?

• The router’s Bluetooth will be enabled for 30 minutes following a reset to factory defaults. There are two ways to reset the router:
• With the router powered on, use a pin to press and hold the Reset button on the back of the router until the LED blinks.
• Log in to the web management page of the router. Go to Advanced > System > Backup & Restore, and click FACTORY RESTORE. The router will reset and restart automatically

For technical support, the user guide and more information, please visithttps://www.tp-link.com/support

References

• Trying to configure the Router? | TP-Link

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>