tc electronic GIT0042338-000 Hall Of Fame 2 Reverb User Guide
- June 6, 2024
- tc electronic
Table of Contents
tc electronic GIT0042338-000 Hall Of Fame 2 Reverb
HALL OF FAME 2 REVERB
Controls
- USB – Connects to your computer for firmware updates and TonePrint editing.
- Decay – Adjusts the length of the reverb.
- MASH LED – Indicates intensity of MASH function.
- Level – Adjusts the level of the reverb.
- Outputs
- Footswitch – Tap footswitch to turn effect on or off. Push down and hold to engage MASH and control the selected parameter.
- Power – Connect a 9 V / >100 mA power supply.
- Tone – Adjusts the brightness of the reverb.
- Pre-Delay – Selects the amount of time between the dry sound and reverb.
- Reverb Type – Select reverb type or TonePrint 1-3*.
- Inputs
NO AUDIO ON TONEPRINT 3?
The default TonePrint 3 setting mutes the output. Use the MASH switch like
a volume pedal to increase the volume gradually.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
TC Electronic
HALL OF FAME 2 REVERB
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Proxy on Street,
Las Vegas NV 89118,
United States
Phone Number: +1 702 800 8290
HALL OF FAME 2 REVERB
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by MUSIC
Tribe can void the user’s authority to use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive
2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive
2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>