EXPLORE SCIENTIFIC Two Room Pop-Up Observatory Tent Instruction Manual
- June 7, 2024
- EXPLORE SCIENTIFIC
Table of Contents
EXPLORE SCIENTIFIC Two Room Pop-Up Observatory Tent
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.
This tent is made of flame-resistant fabric which meets CPAI-84
specifications. IT IS NOT FIRE-PROOF. The fabric will burn if left in
continuous contact with any flame source. The application of any foreign
substance to the product fabric may render the flame-resistant properties
ineffective.
– DO NOT use fuel-burning devices inside or near tent materials.
– DO NOT permit children to light matches, operate burning appliances,
or handle any flame sources in or near the tent.
– DO NOT smoke, use matches, candles, or open flames of any kind in or
near the tent.
– DO NOT refuel lanterns, stoves, or heaters inside the tent.
– DO NOT cook inside the tent.
– DO NOT store flammable liquids inside the tent.
BEFORE YOU BEGIN
Read all instructions thoroughly before beginning set up.
– Select a level site clear of rocks, branches, and other hard or sharp
objects, to set up your tent.
– Do not set up your tent under trees because of potential lightning
strikes or falling tree limbs in inclement weather.
SCAN THE QR CODE TO VISIT OUR PRODUCT PAGE TO VIEW OUR “HOW TO SET UP” VIDEO.
WHAT’S IN THE BOX
#1. Grab the 60 x 60
tent and extension tent. Carefully expand and set aside.
CAUTION: This structure uses a spring steel loop that will pop open
quickly!
#2. Stand the 60 x 60 tent upright, open, and pull from the center to
form the structure.
NOTE: Some twisting of the steel loops might be necessary to form the
correct shape.
#3. Open both entrances and roll the door flaps. Use the attached straps
to tie the flaps.
#4. Stand the extension tent upright, open each side and locate the hook
and loop fasteners.
#5. Locate the hook and loop fasteners on the 60 x 60 tent.
#6. Attach the extension tent to the 60 x 60 tent with the hook and loop
fasteners.
Optional: For a more secure structure, slide stakes through each bottom
loop corner and hammer them into the ground.
#7. Take the paracords and insert one on each top corner loop of the
tents. Make a knot of your choice to secure.
#8. Hammer stakes into the ground and extend the paracords out at a 45°
angle from the tent.
Tighten the paracords as needed by adjusting the slider up the cord.
NOTE: Tents should be taut when staked properly.
#9. Use the 120 x 180 top cover for temporary protection when not in use.
Follow steps #7 and #8 to secure the top cover.
NOTE: Use the same stakes from Step #8 to attach the paracords. The top
cover should be loose and not taught to keep the structure up.
HOW TO FOLD AWAY
Start with the 60 x 60 tent, push one corner into the opposite corner and fold
down the center flat.
Extension tent, fold each side panel to the inside flat.
Rotate the tent 180° and hold as shown with the peak pointing away from you.
Take one corner and connect it to the opposite corner.
Slide the top corner to the left.
Fold in the circles that are formed on each side.