TRADIM Led Wall Dimmer Instruction Manual
- June 7, 2024
- TRADIM
Table of Contents
Instruction Manual
TRADIM Led Wall Dimmer (2485H)
INSTRUCTION MANUAL LED WALL DIMMER 2485H
This LED wall dimmer [3-150W/VA] is suitable for dimming of dimmable
[retrofit] LED lamps (230V, max 70W), incandescent and halogen lamps [230V,
max 120W], 12V halogen lamps in combination with dimmable electronic
transformers [120W max] and low voltage LED lamps in combination with dimmable
LED drivers [120W max). This dimmer has a soft start, in order to prevent peak
currents that have a negative effect on the life span of the LED lamps. With
the 2 way switch, this dimmer can control a (LED) lamp in combination with an
alternating switch
(hotel switch). Trailing edge dimmer (‘R,C’), 230V/50Hz.
FUNCTIONING OF THE DIMMER:
After safe installation, switch on the lamp by pressing the push/rotary knob
(1). Turn the knob (1) to the minimum value by turning it all the way
counterclockwise. The desired starting brightness can be set [profile position
1, 2 or 3) with the slide switch (2) [at the lowest dimming position]. The
maximum brightness is reached by turning the knob (1) clockwise. The correct
profile for the (LED) lamp has been found, as soon as the dimming of the LED
lamp is stable
[from min. to max. brightness] and when the adjustment range is satisfactory.
INSTALLATION:
-
Work safely! Before installing, first turn off the power.
-
Strip the wires sufficiently (approx. 1 cm).
-
Connect the dimmer according to the drawing; if there is only one dimmer, follow drawing A. If it is a hotel switch, follow drawing B
-
Screw the dimmer into the flush-mounted box (when the lamp is off, press the rotary switch (1)).
-
Turn the rotary knob (1) to select the desired dimming position of the (LED) lamp.
-
Use the slide switch (2) to set the desired minimum dimming position (1, 2 or 3) with the rotary switch
(1) set to the minimum position (counterclockwise). -
Mount the frame, the cover plate and the knob.
TOOLS:
- Small flat screwdriver.
Version 2.0 ENG (25/01/19)
Note: Use the Tradim LED Dimming stabiliser to properly dim unstable [filament/led] light. Art. LEDDS6001 The manufacturer is not liable for any damage caused by incorrect use or improper installation of the dimmer. The warranty period is 2 years from the date of purchase, to be proven to the retailer by means of your purchase receipt.
Keep this manual in a safe place in case it is needed for (re)installation!
TRADIM Aalsbergen 9, 6942 SE Didam, The Netherlands www.tradim.nl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>