TRADIM 2600 LED Duo Dimmer Entry Level User Manual

: June 8, 2024
: TRADIM

Table of Contents

TRADIM 2600 LED Duo Dimmer Entry Level
REQUIRED TOOLS
INSTALLATION INSTRUCTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TRADIM 2600 LED Duo Dimmer Entry Level

IMPORTANT!

Always work SAFELY: before installing, switch off the power in the fuse box.
This dimmer is NOT SUITABLE for 12V halogen lamps combined with a magnetic iron core wired coil transformer. Using this combination the dimmer will be permanent damaged. The warranty is thereby invalidated!

THIS LED WALL DIMMER IS SUITABLE FOR DIMMING THE FOLLOWING LIGHT SOURCES:

Dimmable led (ﬁ lament) lamps (230V, max 70W).
Low voltage led lamps combined with dimmable led drivers (max 80W).
Incandescent and halogen lamps (230V, max 100W).
12V halogen lamps combined with dimmable electronic transformers (max 80W).

CHARACTERISTICS OF THIS LED DUO WALL DIMMER:

Trailing edge dimmer (’R,C’) so no humming occurs in both the dimmer and the connected LED lamps.
The dimmer has a soft start to protect the lifetime of the applied led lamps.
Adjusting of the MIN and MAX setting of connected light source(s). through the potentiometers [Figure C].
The dimmer is easy to install in a single, standard ﬂ ush-mounted box.

REQUIRED TOOLS

Small screwdriver.
Stripping pliers, for stripping the wires.

INSTALLATION INSTRUCTION

Strip the wires sufﬁ ciently (approx. 5 mm).
Connect the dimmer according to ﬁ gure A: The brown wire on contact ‘L’ (Figure B). The black load wires to the light source on contacts ~1 and ~2 (Figure B).
Tighten the screws so that the wires are properly clamped.
Screw the dimmer into the ﬂ ush-mounted box, avoid to much tension on the wires behind the dimmer in the box.
Adjust the dimmer before further assembly. See “Adjusting the dimmer”.
Unscrew the nuts and washers from the rotary axis. Install the frame and the cover plate. Screw the nut, with the frame and plate behind it, on the dimmer shaft and tighten it ﬁ rmly. This ensures that the cover clamps securely against the wall. Finally, press the rotary knobs on the axis.

ADJUSTING THE DIMMER

Switch on the connected light source by pressing the dimmer axis.
Set minimum brightness Set the dimmer to the minimum setting by turning the dimmer axis to the left. Using a small screwdriver, turn the “Min set” potentiometer [Figure C] until the lamp starts to illuminate softly.
Set maximum brightness Set the dimmer to the maximum setting by turning the dimmer axis to the right.
Using a small screwdriver, turn the “Max set” potentiometer [Figure C] until the lamp lights up brightly and stable. * Still unstable lights? Use the
Tradim LED dimming stabiliser to avoid any ﬂ ashing/oscillation in the light (Art. LEDDS6001)

The manufacturer and/or supplier is not liable for damage caused by misuse or improper installation of the dimmer. The warranty period is 2 years from the date of purchase. Make a claim? Show the dealer your receipt. Version EN 1.0 (6/12/21). Keep this manual safe for (re)installation!

TRADIM BV Aalsbergen 9, 6942 SE Didam, The Netherlands www.tradim.nl