JOCEL NSBK-200WS2 Wall Mounted Ceramicheater Instruction Manual

: June 3, 2024
: JOCEL

Table of Contents

JOCEL NSBK-200WS2 Wall Mounted Ceramicheater
SAFETY INSTRUCTIONS (to be read before operating the heater)
OVERVIEW
ATTENTION AND MAINTAINS
GENERAL WARRANTY TERMS
TECHNICAL ASSISTANCE
DECLARATION OF CONFORMITY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JOCEL NSBK-200WS2 Wall Mounted Ceramicheater

JOCEL-NSBK-200WS2-Wall-Mounted-Ceramicheater-product

Read the Instruction Manual carefully.

DEAR CUSTOMER
Read these instructions fully before using the heater. Retain these instructions for future reference.

SAFETY INSTRUCTIONS (to be read before operating the heater)

Check whether or not the local power supply mains matches the appliance electric rating printed on the label before operation.
Children should be supervised to ensure that they do not play with the appliance. If the appliance is damaged, do not use it anymore.
Ensure the power supply to the socket into which the heater is plugged is in accordance with the rating label on the heater.
When the appliance is not in operation, please remove the plug from the supply mains.
The plug must be removed from the socket-outlet before cleaning or maintaining the appliance
Don’t remove the plug by pulling the power cord.
Avoid the use of an extension cord as this may overheat and cause a risk of fire.
Keep the mains lead away from the hot body of the heater.
WARNING : In order to avoid overheating, do not cover the heater.
Don’t use this heater in the immediate surroundings of a bath, a shower or a swimming pool. never locate the heater where it may fall into the bathtub or another water container.
The device is intended for household use. Do not use outdoors.
Do not cover or obstruct any of the heat outlet grilles or the air intake openings of the heater.
Always ensure that the heater is not positioned close to curtains or furniture as this could create a fire hazard.
The heater must not be located immediately below an electrical socket outlet.
Do not insert any object through the heat outlet or air intake grilles of the heater.
Do not place this heater near flammable materials, surfaces or substances, as there may be a risk of fire.
Particular care should be taken when the heater is situated in areas occupied by children or invalids.
Always unplug the heater when moving it.
The room which is to be heated should not contain any easily inflammable materials (e.g., petrol, solvents, spray canisters, etc.) or other easily combustible materials (e.g., wood or paper). Keep such materials away from the equipment. risk of fire!!
Do not operate the heater with a damaged cord or plug, or after the heater malfunctions, has been dropped, or is damaged in any manner.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
the heater must be installed at least 1,8 m above the floor.
WARNING: This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided.

This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way to understand the hazards involved.

Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

CAUTION
Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. Never left the room when the product working.

OPERATION OF THE HEATER

NOTE:
It is normal when the heaters are turned on for the first time or when they are turned on after having not been used for a long period of time the heaters may emit some smell and fumes. This will disappear when the heater has been on a short while.

OVERVIEW

Product Description

METHOD OF USE

Face cover
Leading winds door
Control panel
Baseboard
ON/OFF
Remote control

JOCEL-NSBK-200WS2-Wall-Mounted-Ceramicheater-fig-1

Turn on the power button on side of the machine, then the buzzer sounds. The standby symbol lights up on the display.
ON/OFF button: start or shut down on the remote or on the machine.
Press the button to switch gears on the remote, press1 time to control the low-grade 1 sun mark light, which means 1000W, then press 2 times to control the high-grade 2 sun mark light, which means 2000W, then press 3 times to control the automatic function(the default temperature 20 degrees), if the room temperature more 20 degrees, then the air comes out cool air, not heating, if the room temperature less 20 degrees, the air comes out hot air.
Weekly timing board function description
ON/OFF button: carry on the open and shut down operation; when the product is powered on or shutdown, the switch indicator light is on; when the product is powered on, the flame indicator light is on, and the flame brightness is the maximum power output; the default timer key is: “00.00”, the default number of days is “SUN”, the temperature shows room temperature;
Heating button: pressing the heating button to adjust the product’s high and low heating mode; two indicator lights on high-grade, one indicator light on low-grade; at the same time, the temperature display digital screen flashes; the flashing time is 10 seconds;
Temperature adjustment: the temperature can be set in the heating mode; the setting range is 15~38℃; when the set temperature is greater than room temperature, the product shall be heated according to the settings gear, when the set temperature is lower than room temperature, the product shall not be heated.
button, press the “ button, and the indicator light from Monday to Sunday begins to flash, flashing time is 10 seconds, confirm the real-time day of the week by the “+” button;
button: press the “ button, the digital clock screen begins to flash, flashing time is 10 seconds; confirm the real-time hour by “+” button from 01 24 hours
button: press the “ button, the minute the digital screen begins to flash, the flashing time is 10 seconds; confirm the real-time minute by the “+” button from 01 60 minutes
button: set certain time on and off
button: press the “ button to enter the weekly timing mode, it will need +/ – / buttons to adjust the corresponding parameters; through pressing / / button to switch ON OFF: ON is the certain timing start, OFF is the certain timing shutdown); through pressing / buttons to adjust the hour, and minute, to confirm the product timing start and timing shutdown time, you can separately set the timing boot or timing shutdown time; in the boot state, when the set timing boot time is less than the timing shutdown time, the product can not be performed the timing boot operation; when the timing shutdown time is less than the scheduled boot time, the product shall first execute the timing boot, and then perform the timing shutdown;
button: it can only by operated under the condition. Press the “ button is timing (ON) or timing (OFF) selection (switching).
RESET weekly timing time setting clear button.
The backlight display only shows the time and standby buttons after 60 seconds. At the same time, the standby button flickers intervals of 3 seconds. Press any button to light the display screen.

THE INSTALLATION METHODS ON THE WALL

Drill two holes on the flat wall 180cm away from the ground, the distance between the two holes is 46cm. Stuff the stopper or expanding bolt and screw the wood bolt. Instruction as below:
Ring the wood bolt into the keyhole of the wall-mounted warmer and pull down to make the wood bolt embedded into the line slot of the keyhole.

ATTENTION AND MAINTAINS

When using the warmer, the ammeter should be endured the power marked on the mark of the appliance. The outlet must have a reliable ground connection and can endure 10A or above current.
The warmer can’t be placed under the fixed power outlet.
Don’t open the upper cover when using it to avoid water or dirt entering.
The out winds door never be covered to avoid taking place accidents.
When the warmer working, don’t reach the hands into the out winds door, or face of translating winds to avoid being scaled.
Don’t pull the power wire when drawing or inserting the plug and don’t operate the switches with wet hands.
After the warmer operates in the cool wind state for 30 seconds, the warmer can be shut off.
When the fan-motor button is not in position and the fan motor can’t work properly, don’t turn on the heating switch.
When cleaning the dust-proof wet and outside shell, firstly shut off the power and then open the up cover. The tarnish should be slipped away with the soft cloth, don’t clean it with the diluted solvent, toluene, alcohol or alkali scour, and so on.
Clean the outside of the heater by wiping it with a damp cloth and buffing it with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.

STORING THE HEATER
When the heater is not used for long periods of time it should be protected from dust and stored in a clean dry place.

CORRECT DISPOSAL OF THIS PRODUCT

This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling. viewJOCEL-NSBK-200WS2-Wall-Mounted-
Ceramicheater-fig-16

GENERAL WARRANTY TERMS

The warranty is valid only on the presentation of the invoice of purchase.
This WARRANTY is limited exclusively to parts substitution ineffective due to faulty manufacture, made in our workshops.
The elimination of several faults in the scope of the guarantee is made for the repair or replacement of defective parts, according to the discretion of our technical services. Defective parts are our property.
Are not covered under warranty damage caused by transportation, neglect or poor use, improper assembly or installation, as well as external influences such as lightning strikes or power, flooding, humidity, etc.
Lose warranty, all appliances that are not being used according to the instructions, or connected to FEEDING NETWORKS do not guarantee a constant voltage of 220/240V.
The warranty does not cover damages for personal injury or damage caused directly or indirectly in any capacity whatsoever.
This warranty terminates when it is found to have been undergoing repairs, alterations, or interventions by any person not authorized by Joel.

THE WARRANTY EXPIRES

If the appliance has not been installed by an Accredited Technician.
Exceeded the period of 2 years for home appliances and 06 months for industrial appliances, the warranty expires and assistance will be made by charging the costs of manpower, according to current fees.
With the modification or disappearance of the nameplate of the appliance.

TECHNICAL ASSISTANCE

For technical assistance requests, our services are available through the following contacts:

Telef. 00 351 252 910351
Fax: 00 351 252 910367
Email: assistencia@jocel.pt
http://www.jocel.pt.

SEDE:
Rua Dos 5 Caminhos, nº516 4780 – 382 Argemil, Santo Tirso Porto, Portugal
Telef: 252 910 350
email : jocel@jocel.pt
http://www.jocel.pt.