myGEKOgear Dash Camera Orbit 530 User Manual

myGEKOgear Dash Camera Orbit 530 User Manual

Disclaimer

1. Please follow the set-up and usage instructions in the print material that came with this Dashboard Camera (dash cam) product.

2. You should not set/install this dash cam at a place that would obstruct or reduce a driver’s view; make sure your usage complies with pertinent vehicle codes of your state, province, territory or country.

3. You should post the required notices of recordation to occupants inside the vehicle, if voices or other information/signal pertaining to in-vehicle activities
   will be recorded.

4. You should not change the dash cam’s setting or mode of operation or when the vehicle is in motion.

5. The optional driving warning signals, including any visual or audible reminding signals, should not replace your decision-making and judgment that are needed for the proper operation of the vehicle.

6. You should not leave the dash cam in a visible spot when no one is inside the vehicle, to avoid attracting break-ins to steal the unit, or other property.

7. You should avoid extended exposure of the dash cam to direct sunlight or extreme temperatures (either high or low temperature) which tend to degrade or damage the unit and its normal functionality.

8. You should examine, check and/or verify the dash cam at least every six (6) months, including the associated memory cards, to ensure the video reception and recording are working properly. For each use, you should verify that the dash cam unit, the visible lights and the audible sounds are working normally. If there are signs of non-operation or mal-function, you should immediately s eek to replace the product and check to see if the product is covered under any applicable warranty.

9.  The dash cam unit may have additional functionality, such as transmission and recordation of audible or GPS signal or other identification information. If you have privacy concerns about these functions, make sure you follow the instruction to disable these functions.

10. You should use the dash cam unit in the way it is intended. You should not use the dash cam unit in a way that would be illegal or that tends to physically damage the unit, or tends to cause danger to the safe operation of the vehicle or the occupants.

Attention Please! 【About Usage】

1. If your vehicle still provides power to your cigarette 12-volt charger please unplug the device when you turn off your vehicle and plan to have it
   parked for a long period of time to avoid draining the power from your vehicle’s battery.

2. The embedded super capacitor can help to save your recorded file even if the power is off.

3. To avoid breaking down the file recorded, don’t eject the micro SD card immediately after powering off.

4. We suggest using adapter provided to view the footage on the micro SD card.

5. To enable detecting and monitoring function, the power supplier must be enabled.

【About Micro SD Card】

1. Please use microSD card with the size / memory at least 8GB, Class 10 (up to 64GB).
2. Be sure to format Micro SD card before usage. To format card press once and you will get to settings—-Format memory Card —— OK
3. The following information is the card capacity and recording time. (Reference only)

Resolution

| 16G| 32G|

64G

---|---|---|---

2560×1080

| 111min| 223min|

446min

2304×1290| 111min| 223min|

446min

HDR 1920×1080| 122min| 245min|

491min

1280×720 P60

| 122min| 245min|

491min

1280×720 P30

| 189min| 378min|

756min

Product features may change according to region in which it is purchased without notice.

Thank You!

Thank you for purchasing the Orbit 530 dash camera. This user manual contains technical specifications and instructions for use, operate, and install. Please read
this manual carefully before using.

Product Overview

This product is a high-definition digital video camera, with high-quality digital audio & video, and USB charging function.

Package Contents

Orbit 530 Dash Cam

USB Car charger with Cable

_ 16GB microSD Card

_

Windshidld Suction Mount Windshidld 3M sticker Mount

_ **Quick User Guide

**_

Product Features

1. Dash Cam, 1296p 30fps Ultra HD
2. Sony Starvis night vision imaging sensor
3. 150-degree grade A+ high resolution Ultra Wide-angle lens
4.  Wi-Fi APP connection
5. 2.0-inch TFT LCD
6. A.D.A.S. capability (Stop & Go, Driver Fatigue Warning & Headlight Reminder)
7. Support SD card up to 64GB
8. Motion detection & Parking Monitor
9. W.D.R. (Wide Dynamic Range)
10. SOS file locking function
11. Loop recording, Time and Date stamp

Dash Cam Overview

1. Power button                        2. microSD Card Slot    3. LED Indicator
2. Return/SOS Button             5. Up/Replay Button     6. Down/Menu Button
3. OK/ LCD off Button          8. Micro USB Slot         9. Reset Button
4. Microphone 11. Lens           12. Speaker
5. Bracket Slot 14. Display

Where to Install Your Dash Cam

① To have a better view, try to install at the top center of the windshield.
② Make sure the lens is located in a place where the windshield wiper can clean the window to ensure view is clear.
③ Make sure the device is not installed in a place where it will interfere with the safety bag.
④ Make sure the device will not be obstructed by the windshield’s sun control film (window tint).
⑤ Clean the area you desire to have the dash cam placed before sticking the device, and DO NOT move the device for a 24-hour period.

Power O N

Insert the car charger cable into the car’s cigarette lighter and the other end into the Micro-USB port on the device. Make sure to input the microSD Card into the microSD Card slot on device. After turning on, the system will start recording automatically. The LED light will turn flashing when recording mode has started.
*Reminder: Please format microSD card before you start recording. Please refer to page 2 for instructions.

Power Off

Hold down the power button at least 5 seconds to turn off device. To avoid breaking down the last file recorded, do not eject the SD Card immediately after powering off.
If you need to turn it back on simply hold the power button for at least 3 seconds.

Buttons Definition

memu          Playlist : Back to previous menu Replay/Setting : Back to previous menu
| Recording mode : One short click Enter snapshot Snapshot Mode : One short click          Enter playlist Playlist/setting :  Upward  Replay mode : Delete
| Recording mode: One short click leads to setting menu One long press to take a                snapshot Snapshot Mode : One short click to adjust photo resolution Playlist/Setting :      Downward Replay mode :     Lock / Unlock
|  Recording mode: one short click to turn off/on the display Snapshot Mode : One short     click to take a snapshot Playlist/Setting : Confirm Replay mode : Pause/Resume
****| Power button: To turn on/off device

Settings

LED:
Red – Flashing indicates recording Blue – Indicates there is power supplied Return/SOS: Recording Mode: Start emergency recording
Preview Mode: Return recording mode Playback Mode: Return preview model Up / Recording Button: Recording Mode: Enter in to video preview Preview Mode: Delete menu Playback Mode: Toggle to previous file Down Button/ Menu Button: Recording Mode: Enter in setting menu Preview Mode: Lock/Unlock menu Playback Mode: Toggle to next file OK: Screen saver button

Reset:

If the device fails to operate, try resetting the device. Press the reset button using a fine pen or paperclip. Power: Press and hold the power button for 3 seconds to turn on; Press and hold for 5 seconds to turn off.

SD Card Insert and Removal

1. Insert the microSD card into the microSD card slot on the dash cam.

2. To take out the SD card, please gently press the SD card and it should pop out of the slot.
   Caution!

3. Please pay attention to the direction of the microSD card when inserting.

4. If the device and microSD card is incompatible, please insert a different microSD card to try again. (Please refer to the compatible microSD card brands on www.mygekogear.com)

5. Please use a high-speed microSD card (Class 10 or above).

Video Recording Settings

In Recording Mode, press the Down button toenter the settings menu. Press the Up/Down button to choose the setting and press the OK button to confirm.

1. Resolution: 1728x1296P30, 1920x1080P30, 1280X720P30
2. Loop Recording: 1 Minute/ 3 Minutes/ 5 Minutes
3.  Time/ Date: Year/Month/Date, Hour/Minute/Second
4. Microphone: Off / On
5. Driving Safety: Stop and Go: On/Off Driverr Fatigue Alarm: 30 Minutes/ 1Hour/ 2Hours/ 4Hours/ Off Light Reminder: On/Off
6. Recording mode: Monitor Mode / Motion Detection/ Parking Mode /off
7. Bump Auto Record: Off/ Low/ Medium/ High
8. Stamp Setup: Date Stamp: On/Off LOGO Stamp: On/Off Model Stamp: On/Off
9. Exposure：+1.0, +2/3, +1/3, +0.0, -1/3, -2/3, -1.0
10. Frequency: 50Hz / 60Hz
11. Volume Setting: 80%, 100%
12. Button Beep: On / Off
13.  Screen Saver: 1 Minute/ 3 Minutes/ Off
14.  Language: English/ French/ Simplified Chinese
15. Wi-Fi: Off / On
16. App download QR Code
17. WDR: Off / On
18. Format Memory Card: OK / Cancel
19. Format Warning: 15 Days/ 30 Days/ 60 Days/ Off
20. Default: OK / Cancel
21.  Version Info: Check from device

Recording:

When connected to a car charger, the device turns on and start recording automatically. The red icon will show on the screen. The flashing red icon indicates that the device is recording. If you want to protect/lock the current recordings, please press the button and the icon will appear on the screen. It indicates that the current recording will
be locked and will not be overwritten by new video clips.

Replay Mode

In Recording Mode, please press the Up button twice to enter Replay Mode. ReplayMode allows to play back the saved video. You can delete the file by pressing the “Down” button if you would like to delete video file. You can lock the video file by pressing the “Up” button if you would like to lock the video, so it won’t be overwritten. To return to Recording Mode, please press the button.

Connecting to a PC

Orbit 530 can connect to a PC by using a micro USB data cable (not supplied). The supplied micro USB cable is for charging and supplying power only. When the device is connected to a PC, displays on the Orbit 530 screen. On the PC, please select the USB drive and select the “CARDV” folder to view saved videos and photos. Photos will be saved in “PHOTO” folder, and Videos will be saved in “VIDEO” folder. Locked videos will be saved in “EMERGENCY” folder. Recording:

Wi-Fi Function

1. How to down download APP

1. For iOS system, scan QR code or search “myGEKOgear” in App Store, then download the APP
   .

2. Turn on the Wi-Fi on dash cam. Use your smartphone to search Wi-Fi name “Orbit 530-####” and input the Wi-Fi password: 12345678 to connect to the Orbit 530 dash cam.

Note

• Improper operation will cause the device to crash. If the dash cam crashes, press the reset button to reset the camera.
• Don’t leave the camera in direct sunlight or where the temperature could go above 60 degrees Celsius or 140 degrees Fahrenheit for a long period of time.

Technique specifications

N eed more information? Visit our website via www.mygekogear.com

Feel free to contact our service team at service@mygekogear.com if you have any additional questions.
Before Contacting a Service Team Member Please back up all important data stored in the microSD card. The data in the microSD card may be deleted during repair.
The customer service team does not back up your data. myGEKOgear is not responsible for any loss on data.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>