Johan Lewis Isabel Pewter Wall User Manual

: June 7, 2024
: JOHAN LEWIS

Table of Contents

Assembly
Care instructions
Recommended bulb
Specifications
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Johan Lewis Isabel Pewter Wall User Manual

Johan Lewis Isabel Pewter Wall User Manual

Thank you for purchasing this Isabel wall light. Please read the instructions carefully before use to ensure the safe and satisfactory operation of this product.

Warnings!
This product is Class I and must be earthed.

It is recommended that this fitting is installed by a qualified electrician.
This fitting should be fitted in accordance with IEE Wiring Regulations and the Building Regulations.
To prevent electrocution switch off at the mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.
If you are in doubt please consult a qualified electrician.
To avoid damage to concealed wiring during installation, establish the direction of the supply cable before drilling fixing holes.
This product is Class I = and should be fitted to a lighting Supply (with earth) protected by a 5 amp fuse or equivalent circuit breaker.
Indicates that the fitting is suitable for mounting on normally flammable surfaces.
Always be sure to use the correct type and wattage of bulbs as indicated on the fitting. Never exceed the wattage stated.
When changing the bulb, always switch off at the mains and allow the old bulb to cool down before handling. Dispose of used bulbs carefully.

Johan Lewis Isabel Pewter Wall User Manual - Overview

Assembly

Never install your appliance on a wet, freshly painted, or plastered surface. Ensure the house electricity supply is switched off at the fuse box. If removing an existing fitting, note down all wiring connections. Follow the diagram below for fixing detail. Check the fixings will not touch any existing wiring before drilling and attaching the light to the wall. Ensure you thread the wall wires through the black insulating tube fixed to the appliance.

Ensure the house electricity supply is off at the fuse board.
If removing an existing fitting, first note down all wiring connections.
Remove mounting bracket from the fitting by undoing fixing screws at the side of the fitting cup.
Using the mounting bracket as a template, mark and then drill the fixing holes in the wall (ensure holes are drilled into a secure surface). Take care not to damage wiring.
Attach mounting bracket onto the wall using suitable screws. Make sure no wires are trapped in the process.
The weight of the fitting must be supported whilst you make the electrical connections. Lever open the connector block cover with a screwdriver then make the electrical connections as follows, you may require assistance.
• Connect the supply live (normally brown or red) to fitting life (embossed “L”) on the terminal block housing.
• Connect the supply neutral (normally blue or black) to fitting neutral (embossed “N”) on the terminal block housing.
• Connect the supply earth (normally green/yellow or unsheathed) to earth (embossed ” “) on terminal block housing.
Ensure electrical connections are tight and no loose strands of wire protrude from the terminal block then close the connector block cover by snapping back together.
Offer the fitting cup over the mounting bracket and secure with the screws removed from earlier. Ensure that wiring does not interfere with the pull switch mechanism. If the pull cord does not operate correctly please remove and check that wiring is clear of switch.
Fit shade, remove shade ring from bulb holder then offer shade in place and secure with shade ring.
Fit the bulb, type, and wattage as indicated on the fitting (bulb not supplied). The wattage indicated must not be exceeded.
Switch on the electricity supply at the fuse board.