Johan Lewis Ora LED Ceiling light User Manual

: June 7, 2024
: JOHAN LEWIS

Table of Contents

Assembly
Care instructions
Specifications
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Johan Lewis Ora LED Ceiling light User Manual

Johan Lewis Ora LED Ceiling light User Manual

Thank you for purchasing this Ora LED ceiling light. Please read the instructions carefully before use to ensure the safe and satisfactory operation of this product.

Warnings!

For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by the law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or by phone at your Local Authority.
To prevent electric shock, switch off the mains supply before installing or maintaining this product. Ensure other persons cannot restore the electricity supply without your knowledge.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced. The bulb and surrounding parts can become extremely hot during use.
This product is Class II = and should be fitted to a lighting Supply protected by a 5 amp fuse or equivalent circuit breaker.
For indoor use only.

Johan Lewis Ora LED Ceiling light User Manual -
Overview

Assembly

Never install your appliance on a wet, freshly painted, or plastered surface. Ensure the house electricity supply is switched off at the fuse box. If removing an existing fitting, note down all wiring connections. Follow the diagram below for fixing detail. Check the fixings will not touch any existing wiring before drilling and attaching the light to the wall. Ensure you thread the wall wires through the black insulating tube fixed to the appliance.

Ensure the house electricity supply is off at the fuse board.
If removing an existing fitting, first note down all wiring connections.
Remove mounting bracket from the fitting by removing the retaining screws and washers, retain for later.
Using the mounting bracket as a template, mark and then drill the fixing holes in the ceiling (ensure holes are drilled into a secure joist). Take care not to damage wiring.
Attach the mounting bracket to the mounting surface using suitable fixings. Do not attach the fitting to the mounting bracket at this stage. Make sure no wires are trapped in the process.
Lever open the terminal block box cover with a screwdriver then feed supply cable through rubber sleeving and make electrical connections as follows:
Connect supply live (normally brown or red) to fitting life (marked “L”) on the terminal block. Connect supply neutral (normally blue or black) to fitting neutral (marked “N”) on the terminal block.
NO EARTH must be connected to any part of this fitting. If there are any earth wires present in the ceiling these must be terminated into a separate terminal block (not supplied) to ensure continuity of the earth circuit is maintained. Ensure electrical connections are tight and no loose strands of wire are left out of the connector block and the rubber sleeve is seated correctly.
The excess cable must be carefully located inside the ceiling cup or within the ceiling void. Carefully offer fitting over mounting bracket then secure in place with the screws and washers removed earlier.
Once installation is complete, the house electricity may be restored at the fuse box.