Johan Lewis Mushroom Table Lamp User Manual
- June 7, 2024
- JOHAN LEWIS
Table of Contents
Johan Lewis
Mushroom Table Lamp
User Manual
Thank you for purchasing this Mushroom table lamp. Please read the
instructions carefully before use to ensure safe and satisfactory operations
of this product.
Please keep this instruction for future reference.
Warnings!
The supply cable runs through the inside of this product. Take care not to place undue stress on the cable whilst unpacking to prevent the possibility of a poor connection.
If you are in any doubt consult a person competent to give advice on the
assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling or
maintaining this fitting. Ensure the plug is not connected to any power supply
and read instructions before assembly.
Always be sure to use the correct type and wattage of bulbs as indicated on
the fitting. Never exceed the wattage stated.
When changing the bulb, always switch off at the mains and allow the old bulb to cool down before handling. Dispose of used bulbs carefully.
Caution! The bulb and surrounding parts can become hot during use.
For indoor use only.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the finish.
Replace bulbs from John Lewis or established brand of the same type and
compatibility.
Parts list
Assembly
Never install your appliance on a wet, freshly painted surface. Ensure to off at the mains supply before assembling or maintaining this fitting.
Step 1
Unpack the product and remove all packaging. Be careful not to scratch the surface of the product whilst removing the wrapping.
Place the shade over the table lamp and align the holes in the shade with the
holes in the lamp plate.
Secure the shade by fitting the protective washers to the screws and then
tighten the screws using the screwdriver provided. If cross threading occurs,
undo and start again. Take care not to overtighten as this may cause damage to
the fitting.
Step 2
Fit the bulb, type and wattage as indicated on the fitting (bulb not supplied). The wattage indicated must not be exceeded.
You table lamp is now ready for use.
Recommended bulb
- 1 x 3-6 Watt SES energy efficient LED GB
Specification
- Max power: 25W
- Voltage: 220~240V, 50/60Hz
- IP20
- Weight 1.9Kg
Please retain these instructions for future reference.
This symbol indicates that this product should not be treated as normal house-
hold waste and it should be recycled. John Lewis does not operate in store
take back, but as members of the Distributer Take Back scheme have funded the
development and upgrade of recycling facilities across the UK. Please take it
to your nearest collection facility or for further details contact your local
council or visit www.recycle-more.co.uk.
Trouble Shooting:
Why is the light not working when switched on?
Check your power supply is switched on Turn off light and check that the bulb
is inserted correctly Check the bulb is still in working order.
John Lewis partnership
171 Victoria Street
London SW1E 5NN Johnlewis.com
Made in China
References
- John Lewis & Partners | Department Store | Home, Fashion, Tech & More
- Everything you need to know to Recycle More
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>