Johan Lewis ZOla 3 Light Ceiling Fitting User Manual

: June 7, 2024
: JOHAN LEWIS

Table of Contents

Warnings
Instructions for use
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Johan lewis ZOLA 3 LIGHT CEILING FITTING
Thank you for buying this Zola ceiling fitting.
Please read the instructions and warnings carefully before use to ensure safe and satisfactory
operation of this product.

This product is Class I and must be earthed.

Warnings

It is recommended that this fitting is installed by a qualified electrician.
This fitting should be fitted in accordance with IEE Wiring Regulations and the Building Regulations.
To prevent electrocution switch off at the mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electricity supply without your knowledge.
If you are in doubt please consult a qualified electrician.
To avoid damage to concealed wiring during installation, establish the direction of the supply cable before drilling fixing holes.
This fitting should be fitted to a lighting supply with a protected 5 amp fuse or equivalent circuit breaker.
Indicates that the fitting is suitable for mounting on normally flammable surfaces.
Always be sure to use the correct type and wattage of bulbs as indicated on the fitting. Never exceed the wattage stated.
When changing the bulb, always switch off at the mains and allow the old bulb to cool down before handling. Dispose of used bulbs carefully.
This fitting is designed for use with self-shielded tungsten halogen lamps only =

Instructions for use

Ensure the house electricity supply is off at the fuse board.
If removing an existing fitting, first note down all wiring connections.
Remove mounting bracket from the fitting by removing the retaining screws (washers) and retain for later.
Using the mounting bracket as a template, mark and then drill the fixing holes in the ceiling (ensure holes are drilled into a secure joist). Take care not to damage wiring.
Attach the mounting bracket to the mounting surface using suitable fixings. Make sure no wires are trapped in the process.
Lever opens the enclosed connector block using a small flat-bladed screwdriver. Make electrical connections as follows:
Connect supply live (normally brown or red) to fitting life (marked “L”) on the terminal block.
Connect supply neutral (normally blue or black) to fitting neutral (marked “N”) on the terminal block.
Connect supply earth (normally green/yellow or unsheathed) to earth (marked “ ”) on the terminal block.
Ensure electrical connections are tight and no loose strands of wire are left out of the connector block. Ensure terminals and rubber sleeves are correctly seated then close connector block housing.
Carefully offer fitting over mounting bracket then secure in place with the screws and any washers removed earlier.
Fit the bulbs, type, and wattage as indicated on the fitting. The wattage indicated must not be exceeded.
Do not touch halogen bulbs with bare hands as this will shorten their life.
Fit the glass. Remove the shade ring from the lamp holder place the ring into the tool provided.
Place the glass over the lamp holder and secure using the shade ring that is in the tool.
Switch on the electricity supply at the fuse board.
Please retain this information leaflet for future reference