woox Smart Garden Irrigation Control User Guide
- June 7, 2024
- woox
Table of Contents
woox Smart Garden Irrigation Control User Guide
Smart Garden Irrigation Control
Specification
Waterproof: IP44
Water pressure range: 0.2-0.7MPa
Battery: DC 1.5V AA x 4
Wireless connection: Zigbee 3.0
Connection distance: indoor 10-30m
Frequency: 2.400-2.483GHz
Working temperature: 0 – 45
Working humidity: 0-95%RH
Package Includes:
- Smart Garden Irrigation Control x 1
- DC 1.5V AA battery x 4
- 26.5mm G 3/4″ adapter x 1
Support
If you need further help or have comments or suggestions please visit www.wooxhome.com
Introduction
The smart garden irrigation control is for configuring your irrigation system with automatic schedule and saving water. With the Zigbee technology inside, a Woox zigbee gateway is needed to use this product. The smart garden irrigation control can be controlled remotely from anywhere via Woox home app, it can also work with other WOOX smart products.
Requirement to Use
- Woox home app
- Woox zigbee gateway (not included)
Installation
- Install battery.
Press the at the bottom and grab the upper housing to open the garden irrigation.
Open the housing.
Insert 4 new AA batteries and close the housing.
Notes:
* Only use Alkaline battery.
* Replace the battery at the beginning of the watering season
* If LED light indicator is red or not visibility, that means battery is low.
* When garden irrigation control is not in use for an extended period of time, remove the battery to avoid oxidization. 
Clip the bottom as above picture, then push the top into main body as shows
as arrow to finish the battery installation.
- Install the garden irrigation control
- Loosen external ring nut C.
- Tighten 3/4″ female connector B on faucet A.
- Tighten external ring nut C to garden irrigation control housing.
Notes:
- Regularly wash the filter to prevent clogging
- Remove from faucet when temperature reaches below 3 , drain all water and remove batteries to avoid oxidization.
- Do not use with operating pressure below 0.2Mpa or higher than 0.7Mpa, and with water temperature exceeding 45
- Do not install into any type of valve box or under the soil level.
- Do not submerge in water or other liquids.
- Use with tap water only.
- Keep the cover closed to protect against outdoor elements.
Set up the smart garden irrigation control with Woox home app
- Download and install the app “WOOX Home” from Apple App Store or Google Play Store on your mobile device.
- Launch the app “WOOX Home”
- Create a new account or log in to your existing account.
- Tap “+” to add the device.
- Select the applicable product type from the list of products.
- Select a Zigbee Gateway.
- Ensure the indicator light is flashing. If the indicator light isn’t flashing: press and hold the reset button for 5 seconds until the indicator light starts to flashing.
- Press confirm button in the Woox home app.
- The app will now search for the device and register is to your account.
- Enter the device name.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>