Mi Vacuum Cleaner G10 Instruction Manual
- June 7, 2024
- Mi
Table of Contents
Mi Vacuum Cleaner G10 Instruction Manual
Mi Vacuum Cleaner G10 Quick Start Guide
-
Do not vacuum liquids. Do not directly clean the vacuum cleaner with water.
-
Do not vacuum burning or smoking substances, such as unextinguished cigarette butts, or hard or sharp objects like nails.
-
To prevent injury, do not touch rotating parts while the vacuum cleaner is running.
-
Do not charge or store the vacuum cleaner near heat sources or in humid areas, such as by a radiator or in a kitchen or bathroom.
How to Use
Installing the Accessories onto the Vacuum Cleaner
Note: Mini electric brush should not be used with the extension rod
Charging
Fully charge the vacuum cleaner before turning it on for the first time and
after each use. The total charging time is about 4 hours.
_ Charging the vacuum cleaner with the charger
_
Charging the vacuum cleaner on the charging mount
How to Use
Setting Language
Press and hold the button for 3 seconds to open the language list, then press
the button to scroll through the language to select the desired one. Press and
hold the button for 2 seconds to use the selected language.
Note: The display screen will go off if there is no operation for more
than 10 seconds
Switching Suction Levels
Press the button to switch suction levels of eco, standard/auto, and high
power. The corresponding suction level will be highlighted on the display
screen. Only when using the smart high torque brush bar, the auto mode will be
activated and the notification of “Auto” will appear on the display screen.
The vacuum cleaner will then automatically switch the suction level between
the floor/tile and the carpet.
Note: Stop the vacuum cleaner at any time while cleaning, and it will
continue to use the last selected suction level when started again.
Working Modes
-
Non-continuous Mode
Hold down the power button to start the vacuum cleaner, then release to stop it.
-
Continuous Mode
Press the button to enable Continuous Mode, then press the power button to turn the vacuum cleaner on. To exit Continuous Mode, press the button .
Notes:
In Continuous Mode, the vacuum cleaner will enter into standby mode when pressing the power button, and resume running if pressing the button again.
When the vacuum cleaner keeps in standby mode for more than 10 seconds, its display screen will go off and the vacuum cleaner will then exit the Continuous Mode.
Cleaning
Washable Parts
These parts must be separated from the vacuum cleaner or assembly prior to
cleaning. Make sure the washed parts are thoroughly dry for at least 24 hours.
Warning: Only the above parts are washable, the rests and the vacuum cleaner itself are non-washable.