ANKER Selfie Stick with Tripod User Guide
- June 7, 2024
- Anker
Table of Contents
Welcome Guide
selfie stick with Tripod
Using Your Selfie Stick
Bluetooth pairing
Press the camera button for 3 seconds until the blue light begins flashing. With your phone or camera, search for the “Anker 7163” Bluetooth device and pair. The blue light will remain steady once the pairing is complete.
To turn off Bluetooth, press the camera button for 3 seconds.
Opening the
phone holder
Flip the phone holder up and rotate it to the horizontal position, relative to the camera button.
Placing your phone
Place your phone in the holder and adjust the sides for a secure fit.
Taking a photo
Press the camera button on the selfie stick to take a photo. If this does not work, go into your phone’s settings and enable the option to take a photo with the volume button.
Placing your GoPro
Loosen the screw on the right side of the phone holder, then flip it over so that the GoPro holder is in the appropriate position.
Using the tripod
Open the tripod legs at the bottom of the theselfie stick, and place them on a flat surface. Remove the camera button remote.
Attention
| To preserve battery lifespan, use and recharge at least once every 4 months
---|---
| Use original or certified cables
| Don’t expose to liquids
| Don’t disassemble
| Avoid dropping
| Avoid extreme temperatures
Ensure your phone and the cradle are fully secure before use.
Specifications
| Size(when retracted) | 195 x 46 x 27 mm / 7.7 x 1.8 x11 in |
|---|---|
| Length max <=> (when extended) | 605 mm / 23.8 in |
| Weight | 155g/Soz |
| Input | 5V/ 0.1A |
| Battery Life | 20 h |
Declaration of Conformity
Hereby, Anker Innovations Limited (or Anker Technology Co., Limited) declares
that product type A7163 is in compliance with Directive 2014/53/EU.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
RF Warning Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Customer Service
18-month limited warranty
Lifetime technical support
We hope you never have the need, but if you do, our service is friendly and
hassle-free.
1-800-988-7973 | Mon-Fri 9:00-5:00 PST
(US)
44(0)1604 936200 Mon-Fri 6:00-11:00(GMT)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>