eureka Vacuum Cleaner User Guide
- June 7, 2024
- Eureka
Table of Contents
eureka Vacuum Cleaner User Guide
Where to find important Vacuum information
Keep this information
Write the model, type and serial number here:
Date of purchase (keep your receipt) __
Model number and type _____
Serial number ____
Find these numbers on a label on the middle back side of the vacuum cleaner.
Refer to these numbers when ordering parts and accessories or if service is
needed
Important safeguards
When using an electrical appliance, basic precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER
WARNING
To reduce the risk of fire, electric shock, or injury:
- Do not use outdoors or on wet surfaces.
- Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing.
- Do not allow to be used as a toy. Close attention is necessary when used by or near children.
- Use only as described in this manual. Use only manufacturer’s recommended attachments.
- Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call the Eureka Customer Service HELPLINE at 1-800-282-2886.
- Do not pull or carry by cord. Do not use cord as a handle. Do not close a door on cord or pull cord around sharp edges or comers. Do not run vacuum cleaner over cord. Keep cord away from heated surfaces.
- Do not use extension cords or outlets with inadequate current carrying capacity. • Tum off all controls before unplugging.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- Do not handle plug or vacuum cleaner with wet hands.
- Do not put any objects into openings. Do not use with any openings blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
- This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
- Do not place vacuum cleaner on furniture or stairs as the brush roll may cause damage. Use extra care when cleaning stairs. Place vacuum cleaner on floor with the handle in storage position while using attachments.
- Do not pick up anything that is buming or smoking, such as cigarettes, matches, or hot ashes.
- Do not use without dust cup, filter and screen in place.
- Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
- Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present. • Store your vacuum cleaner indoors in a cool, dry area.
- Keep your work area well lit.
- Unplug electrical appliances before vacuuming them.
- WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and to cause birth defects or other reproductive harm. For more information go to www.P65Wamings.ca.gov.
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock , this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electncian to install the proper outlet. Do not change the plug in any way.
Motor Do Not Oil the motor or the brush roll at any time. The bearings are permanently lubricated and sealed.
What comes in the carton
- Important safeguards
- Vacuum cleaner
- Dusting brush (NEU180-NEU187)
- Upholstery tool (NEU180-NEU187)
- Crevice tool (NEU180-NEU187)
- Handle
- Turbo brush (NEU182-NEU188 except NEU182A)
- 2-in-1 upholstery tool (NEU188)
- Flexible telescoping crevice tool (NEU188)
Accessories may vary depending on which model was purchased.
How to assemble your vacuum cleaner
- Vacuum cleaner with dust cup.
- Slid handle into top of vacuum cleaner. Push down until it click
- Store accessories on back of vacuum cleaner.
- Loop hose over hose retainer.
- Push loose end of hose securely onto hose inlet.
- Wrap cord onto upper and lower cord wrap.
- Store turbo brush on front of handle Align Brash opening with slot and push to snap tool into clip.
How to identify parts of your vacuum clearner
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>