Eureka NEU180 Power Speed Multi-Surface Lightweight Upright Vacuum Owner’s Manual

Eureka NEU180 Power Speed Multi-Surface Lightweight Upright Vacuum

Important safeguards

When using an electrical appliance, basic precautions should always be followed, including the following:
WARNING
TO reduce the risk  of fire  electric shock, or injury:

• Do not use outdoors or on wet surfaces.

• Do not  leave vaccum cleaner when plugged in Turn off the switch and unplug the electrical cord when not in use and before servicing.

• Do not allow to be used as a toy. Close attention is necessary when used by or near children.

• Use only as described in this manual. attachments.

• Do not use with damaged cord or plug.
  If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call the Eureka Customer Service HELPLINE at 1- 800-282-2886.

• Do not pull or carry by cord. Do not use cord as a handle. Do not close a door on cord or pull cord around sharp edges or corners. Do not run vacuum cleaner over cord. Keep cord away from heated surfaces.

• Do not use extension cords or outlets with inadequate current carrying capacity.

• Turn off all controls before unplugging. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

• Do not handle plug or vacuum cleaner with wet hands.

• Do not put any objects into openings. Do not use with any openings blocked; keep free of dust, lint, hair, and anything that may reduce  airflow

• This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, away from openings and moving parts.

• Do not place vacuum cleaner on furniture or stairs as the brush roll may cause damage. Use extra care when cleaning the handle in storage position while using attachments.

• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
  screen in place.

• Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt. combustible liquids such as gasoline, or use in areas where they may be present.

• Store your vacuum cleaner indoors in a cool, dry area.

• Keep your work area well lit.

• Unplug electrical appliances before vacuuming them.

• Warning This product can expose you to chemicals including Styrene, which is known to the State of California to cause cancer, and Bisphenol-A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

SAVE THESE INSTRUCTION

To reduce the risk of electric shock this appliance plug( one blade is wider than the other)
This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

Motor
Do not oil the motor or the brush roll at any time. The bearings are permanently lubricated
and sealed.

What comes in the carton

The below parts and accessories are included in all NEU180 series. NEU180, NEU182A, NEU182B, NEU181, NEU188, NEU188A

Parts

Accessories

The below additional accessory is also included with models:

NEU181, NEU188, NEU188A

The below additional accessories are also included with models:

NEU188, NEU188A

Accessories may  vary  depending on which   model was purchase

How to assemble your vacuum cleaner

How to identify parts of  your vacuum cleaner

Headlights are included on select models only (NEU188, NEU188A).
Accessories may vary depending on which model was purchased.

For filter maintenance instructions

How to use vaccum cleaner

How to use accessories

caution
When using tools, always place handle in upright position. Make sure vacuum cleaner is turned off while attaching tools.

•  Place vacuum in upright position.

• Turn height adjustment knob to highest position.

• Pull up on hose connection to release hose end from hose inlet
  (Fig. 1)

• Push end of hose into top of handle and twist clockwise until it clicks
  (Fig. 2)

• Press handle release latch and pull out handle with wand
  (Fig. 3)

• To attach accessories, push desired tool onto end of wand
  (Fig. 4)

• To use accessories without handle and wand, push desired tool directly onto end of hose
  (Fig. 5)

Crevice tool (NEU180, NEU181, NEU181A, NEU182A, NEU182B)- NEU181A, NEU182A, NEU182B)
Use for baseboard edges, corners, detailing chairs, sofas, dryer vents and tooth spaces Upholstery tool (NEU180, NEU181
Use for furniture, chairs sofas and mattresses.

2-in-1 upholstery tool (NEU188)
Use brush to vacuum upholstered surfaces or pick up debris. Use felt portion to clean delicate surfaces Press thumb release and lift brush up and out of the way.

Flexible telescoping crevice tool (NEU188) – Press button and pull to extend tool to desired length. To use brush, pull to swivel into position. Use for baseboards, crevices and tight spaces.

Dusting brush (NEU180, NEU181,NEU181A, NEU182A, NEU182B) Use for furniture, drapes blinds, drawers and vents.

Turbo brush (NEU181, NEU181A, NEU188, NEU188A)- Use to remove pet hair from stairs, carpet and upholstery.

How to maintain dust cup and filters

Dust cup- Empty after each use

Press release button and lift off dust cup

Hold dust cup over wastebasket and press lever to release bottom lid. Debris will empty

Close bottom lid until it clicks.

Washable dust cup filters – Clean monthly

Pull dust cup latch to lift up dust cup lid.

Lift out foam filter and shake off dust. Rinse foam filter and dry THOROUGHLY

Grip tabs and lift out filter screen. Twist bottom of filter screen counterclockwise to unlock and pull apart. Shake off dust. Rinse screen and dust cup. Dry all THOROUGHLY. Reassemble screen; twist clockwise to lock.

Align tab on filter screen with slot on back of dust cup and drop into position.

Reinstall foam filter.

Close cover until it clicks.

Warning:
Never operate vacuum cleaner without foam filter, filter screen and . A dust cup in proper position.

How to clear a blockage

CAUTION
Make sure vacuum is turned off and power cord is unplugged. If vacuum is not cleaning floors, or if no suction at end of hose, check to be sure air path is not blocked.

• Press release button and lift off dust cup
  (Fig. 1).
  

• Empty debris. Hold over wastebasket and press lever to release bottom lid
  (Fig. 2).

Remove any debris and shake off dust. (See maintenance instructions on page 9.)

• Loosen end of hose.
• Use a rod or similar blunt implement to clear a blockage in wand or hose. Flex hose to loosen debris (Fig. 3). Use caution if there is any risk that glass or nails could have become imbedded in hose.

• Use finger to check for debris in air path
  (Fig. 4).
  

• Reinstall filter and filter screen inside dust cup and position dust cup onto vacuum cleaner.

Warning
: Never operate vacuum bleaker without foam filter, filter Screen and dust cup in proper Position.

How to maintain brush roll

CAUTION
Make sure vacuum is turned off and power cord is unplugged.

• Step on handle release to lower handle.
• turn vacuum face down  on floor
• To avoid unnecessary service calls, check brush roll for debris.
• Use scissors to clip heavy threads or strings.

How to maintain turbo brush

Grasp collar and twist to unlock cover. Lift cover up.

With open cover  use finger or small brush to clear accumulated pet hair from bristles.

Close cover and twist collar to lock.

How to replace brushroll or belt

Caution
Make sure vacuum is turned off and power cord is unplugged.

• Step on handle release and lay vacuum cleaner face down.

• Use Phillips screwdriver to remove 6 screws from brushroll cover
  (Fig. 1)
  

• Lift off cover. Refer to for location of screws.

• Rotate right end of brushroll and lift out
  (Fig. 2)
  Lift out left end of brushroll.

• To replace belt, position new belt around motor shaft
  (Fig. 3)
  

• Loop new belt around brushroll shaft at left end of brushroll
  (Fig. 4)
  

• To reposition brushroll into base, pull belt down and insert left end of brushes first  align brushroll end cap  with slot so it  fits  into position
  (Fig. 5).

• Press right end of brushroll into position.

• To replace brushroll cover, align slot on cover with tab
  (Fig. 6)
  and snap cover into place. Replace 6 screws
  (Fig. 7).
  

Problem solving

The eureka  two -year limited warranty

Midea America Corp. (“Eureka”), subject to the terms and conditions herein, warrants this vacuum cleaner to be free from defects in material and workmanship for a term of two years from the date of original purchase when used in accordance with the Eureka operating and maintenance instructions and under normal household usage. This warranty is granted only to the original purchaser and members of immediate household, and is applicable only to original purchases from Eureka authorized resellers.
What eureka will do
Eureka will, at its option, repair or replace a defective vacuum or vacuum part that is covered by this warranty. Repairs may be performed using new or refurbished parts that meet or exceed elects to replace the vacuum, the replacement may be a reconditioned unit. Depending on availability of products, Eureka reserves the right to provide you with a replacement product that is the same or similar, or substitute equivalent of the original product. As a matter of warranty policy, Eureka will not  refund the consumers purchase price

This warranty does not cover

• Normal wear and tear of the vacuum and vacuum parts that require replacement under normal use light bulbs, brush-roll, bristles, impellers and cleaning.
• Damages or malfunctions resulting from: improper or unreasonable use or maintenance, abuse, negligence, failure to follow instructions contained in any written materials that accompany the product, deterioration by reason of excess moisture, corrosive atmosphere, lightning, power surges, connections to improper voltage supply, unauthorized alteration, or other external causes such as extremes in temperature or humidity, accidents, misuse, or acts of God. This warranty also does not cover damage resulting from repair or attempted repair by anyone other than Eureka or an authorized Eureka Warranty Station. This warranty is not applicable to any product that has been altered or on which the serial number has erasing, or forging any proof-of-purchase documents voids any applicable product warranty.

Obtaining warranty service

To obtain warranty service you must contact the Eureka Service Team, toll free, at 1-800-282-2886 or email customerservice@mail.com
warranty claim and procedures to be followed. All warranty claims must include submission of proof-of-purchase documentation. For additional information, you may also visit www.eureka.com.
insurance charges if the defective product(s) must be shipped for warranty service or warranty evaluation; however, Eureka or a Eureka Authorized Warranty Station will pay the return shipping charges if repairs are covered by the warranty. When returning parts for repair, you must include the model, type and serial number located on the rating plate. If any product submitted for warranty service is found to be ineligible, an estimate
of repair cost will be furnished and the repair performed only if requested by the owner and upon receipt of payment or acceptable arrangements for payment.

Further limitations and exclusion

Any warranty that may be implied in connection with your purchase or use of the vacuum, including any warranty of Merchantability or any warranty of Fitness For A Particular Purpose is limited to the duration of this limited warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
limited to the relief expressly provided above. In no event shall the manufacturer be liable for any consequential or incidental damages you may incur in connection with your purchase or use of the vacuum. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
This warranty gives  you specific legal rights you may also have other rights, which may vary be state

Midea America Corp.
200 Rivers Edge Drive
Medford, MA. 02155
USA

Do not return to the store, call Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
Eureka stands by our Clean Promise seal. Learn more at www.eureka.com/cleanpromise

References

• Eureka - Vacuums for all your cleaning needs
• P65Warnings.ca.gov

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>