WALI Speaker Wall Mount Instruction Manual

WALI Speaker Wall Mount Instruction Manual

Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.

CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.

• Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious personal injury.
• Safety gear and proper tools must be used. This product should only be installed by professionals.
• This product is designed to be installed on wood stud walls, solid concrete walls or brick walls.
• Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
• Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
• This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
• This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

IMPORTANT:

Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, telephone your local distributor for a replacement.

MAINTENANCE:

Check that the bracket is secure and safe to use at regular intervals (at least every three months).

Supplied Parts List

1. Mount A(x2)

2. M5x12 Screw B(x4)

3. M4x25 Screw C(x4)
   

4. Concrete Anchor D (x4)
   

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
• Tighten wood screws firmly, but do not over tighten. Over tightening can damage the screws, greatly reducing their holding power.
• Make sure that mounting screws are anchored into the center of the studs. Use of an “edge to edge” stud finder is highly recommended.
  

2a Wood stud Mounting

• Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly recommended Based on their edges, drew a vertical line down each stud’s center.
• Place metal wall plate on wall as a template. And mark the center of the two mounting holes. Make sure that the mounting holes are on the stud centerline.
• Drill two 1/8″(3mm) dia. Holes 1″(25mm) deep. Secure it using two screws-Part C, make sure that the wall plate is level as shown in figure.
  

2b Sold Brick and Concrete Wall Mounting

• Use the metal wall plate as a template to mark two holes on the wall as shown in figure.
• Drill two 7/32″(5.5mm) dia. Holes 1.2″(30mm) deep. Insert a Concrete Anchor(Part-D) into each of these holes. Attach the wall plate to the wall using two screws(Part-C), make sure that the wall plate is level as shown in figure.
  
  

3. Attach Speaker to top bracket using Screwa-part B.

4.Lastly, Assemble speaker with top bracket onto bracket set and wall plate securely

5.Angle Adjustments

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>