My TurboClean/PowerForce/PowerClean PowerBrush Pet has No Spray | Support
- June 7, 2024
- Bissell
Table of Contents
If you are experiencing No/Low Spray, follow these steps to resolve:
Make sure trigger is pressed down when performing wet passes
-
Turn off and unplug machine
-
Remove clean water tank lifting up on handle, set aside
-
Turn upper cord wrap over and remove power cord, set aside
-
Remove upper handle
- Press black button below upper power cord wrap and pull up on handle
-
Remove middle handle
- Press black button below lower power cord wrap and pull up
-
Slide middle handle back onto lower body of machine until it clicks
-
Slide upper handle into middle handle until it clicks
-
With machine unplugged and turned off pull trigger
- Is there pressure in the trigger?
- Yes > Fill clean water tank
- No > Order new middle & upper handle > Go to Parts & Supplies
-
Inspect clean water tank and cap for cracks, damage, or deformation
- If damaged or deformed, replace clean water tank or cap > Go to Parts & Supplies
- If cap is missing red gasket, replace cap > Go to Parts & Supplies
-
Reseat clean water tank on machine until it clicks
- If tank does not click into place, order a new clean water tank > Go to Parts & Supplies
-
Plug machine in and turn on
-
Check for spray by pressing down on the trigger and performing a few wet and dry cleaning strokes
- Has this resolved your issue?
- Yes > Great! Glad we can get you back to cleaning!
- No > Contact Us
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>