LINEA Tiger CP Chair Instruction Manual
- June 3, 2024
- Linea
Table of Contents
Tiger CP Chair
Instruction Manual
ERGONOMIC USE
For correct posture it is necessary adjust the height and angle of the seat, in order to balance the pressure on the spine and keep feet well lean on the ground. Sit with trunk up upright position letting the backrest adheres perfectly to the hips, creating a 90° angle with the knees.
| |
---|---|---
ADJUSTMENTS
-
A. Seat height adjustment
Operate the lever upwards, located under the front of the sitting right. The seat is raised or lowered by decreasing o increasing body pressure. -
B. Back angle adjustment
Turn the knob situated at the right side of the chair in an anticlockwise direction to unlock the chair back. Adjust to the desired angle and turn the knob in a clockwise direction to lock in position. -
C. Back position adjustment
Turn the knob in a clockwise direction to decrease the tilt tension, or in an anticlockwise direction to increase the tilt tension. Adjust according to user’s body weight. -
D. Back height adjustment
To release the ratchet mechanism, lift the back to the highest position and then lower it smoothly to the lowest. Lift up slowly in steps and stop when the lumbar support is at the right level.
SAFETY
Use this product only for seating one person at a time. Do not use chair unless all bolts, screws and knobs are tight.At least every six months, check all bolts, screws and knobs to be sure they are tight. If parts are missing, broken or worn, stop use of the product until repairs are made using factory authorized parts. Failure to follow these warnings can result in serious injury. The seating product you have has been designed for normal use, which typical office environment for 8 hours per day, 5 days per week. Care should be taken to avoid hazardous environments and incorrect use: the chair should not be too close to cables, stairs, doors, heat sources etc. and the user should never stand on the seat or sit on the arms, etc.
MAINTENANCE
-
Cleaning
Depending on the fabric utilised, best results are usually obtained by brisk hand brushing or by vacuuming. Surface stains can be removed with a damp sponge; more stubborn stains can be treated with a dry cleaning spray or gentle detergent. -
Repairs
Repairs to or maintenance of the regulating mechanism and gas column of the chair should be carried out only by authorised personnel.
GARANTEE
(VALID FOR 2 YEARS)/ GARANTIE (2 ANS)
The guarantee is valid from date of purchase shown on the invoice/sales
receipt. The guarantee does not cover normal wear to parts which undergo
continuous use, such as fabric and castors; damage due to incorrect use or non
observance of the user’s guide; inapproriate maintenance. In cases where the
chair is used for more than 8 hours per day, the guarantee is reduced relative
to the work shift periods. The manufacturers cannot enter into debate on any
issue beyond those outlined above. The guarantee is not renewable or
extendable.
Linea Fabbrica S.r.l.
Via Thonet , 5
33044 Manzano (UD)
Tel: +39.0432 747111
Fax: +39.0432 747199
info@lineafabbrica.it
www.lineafabbrica.it
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>