LINEA 7523010 Garden Lights Strip Instructions

: June 9, 2024
: Linea

Table of Contents

INTRODUCTION
CONTROL DIMMING
SYMBOL
Assembly
INSTALLATION OF THE LIGHTS
INSTALLATION OF THE LIGHTS
SAFETY
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LINEA 7523010 Garden Lights Strip

INTRODUCTION

LED 4,5W AC/DC 12V
4,5 Watt
2500 Kelvin
7,5 Lumen
25.000 Hours
On/Off 10.000
Non-Dimmable
Instant full light
Power factor > 0,5
Failure < 5% after 1.000h
Failure < 10% after 6.000h
Flux > 80% after 6.000h
CRI > 65
Non Replaceable Light Source

7523010

AC/DC Converter

CONTROL DIMMING

Connector

SYMBOL

Symbols

Assembly

DC Transformer 24W
AC Transformer 60W and 150W

INSTALLATION OF THE LIGHTS

Use only Garden Lights transformers (Class II, IP44)
DO NOT use the AC/DC converter when using a Garden Lights DC Transformer 24 W (Product no: 6270011).(See Figure 1)
When using a Garden Lights AC Transformer (Product no: 6210011 or 6211011) the AC/DC converter must be connected. (See Figure 2)
Components are not replaceable. If a product is damaged, the product must be destroyed and disposed of responsibly.
When the female socket is not used, always place the socket cover to keep the product waterproof.
Connect a maximum of 5 Linea All Seasons LED strings to the transformer.

Note: If the Linea does not light up, turn the male plug around.

For questions about parts, service, any complaints or other matters, you can contact us at any time.

E-mail: info@garden-lights.com.

This product meets the EU standards for health, safety and environmental protection.

The product meets the requirements of the applicable UK guidelines.

This product answers to the safety requirements specified in the regulations of the EAEU.

The packaging and product must be sorted separately for recycling.

Discarded electrical equipment must not be put in the household waste. If possible, take it to a recycling company. For details of recycling, contact a municipal waste processing company or your dealer.

INSTALLATION OF THE LIGHTS

Install the products in the desired position and lay the cables so they can be comfortably connected to the transformer or main cable.
If products are provided with a drain hole for water, this hole must be pointing downwards.
Use non-corrosive fixing materials (supplied as standard) if you want to bolt the products down.
Connect the lights to the main cable by using the connector as shown in figure on page 4.
Consult the manual of your transformer for more information.

SAFETY

Always fit this product so that it can still be accessed for servicing or maintenance. This product must not be permanently embedded or bricked in.
Turn off the system by pulling the plug of the transformer from the socket for maintenance.
Regularly clean the product with a soft, clean cloth. Avoid abrasives that can damage the surface.
Clean products with stainless steel parts with a stainless steel cleaning agent once per six months.
Do not use aggressive chemical cleaning agents when cleaning the product. This can cause irreparable damage.
Protection class III: this product may only be connected to safety extra-low voltage up to a maximum of 12 Volt.
This product is suitable for outside temperatures of: -20 to 50°C.
Do not use this product in areas where combustible gases, fumes or liquids may be stored.