SANITAS SIL 06/SIL16 Infrared Lamp Instructions
- June 7, 2024
- Sanitas
Table of Contents
SANITAS SIL 06/SIL 16 Infrared Lamp Instruction for Use
1. About the infrared lamp
Application
This infrared lamp is only intended for radiating the human body.
Infrared radiation causes warmth to be transported to the human body. The blood supply in the radiated skin is increased and the metabolic turnover in the field of temperature enhanced. The mode of action of the infrared light encourages the body to heal; healing processes are thus assisted in a specific area.
Infrared light can be used as a parallel treatment in diseases of the ear, nose and throat and to assist in facial and beauty care, especially in case of impure skin.
However, first ask your family doctor whether application in the individual case is advisable from a medical standpoint.
Included in delivery:
- Infrared lamp
- Protective eyewear
- These operating instructions
Note: Warranty restriction
The infrared bulb included – as with all light sources – is not subject to the
warranty.
2. Signs and symbols
The following symbols appear in these instructions or on the device.
3. Notes
Please read these instructions for use carefully and keep them for later use, be sure to make them accessible to other users and observe the information they contain.
Safety notes
Warning
-
This infrared lamp is only intended for radiating the human body.
-
Always use the protective eyewear supplied during usage.
-
Before use, ensure that all packaging materials are removed and that there is no visible damage to the unit or accessories. When in doubt, do not use the unit and contact your dealer or the customer service address provided.
-
Always ensure that the appliance is on a secure and even surface.
-
The lamp housing and the infrared lamp become very hot during operation. There is a risk of burning if these are touched. Always let the lamp cool down first before touching it.
-
Inflammable objects must be kept at a distance of at least 1.0 m from the infrared lamp. Do not hang the appliance on the wall or from the ceiling.
-
Connect the unit only to the mains voltage listed on the type plate.
-
Do not dip the unit into water and do not use it in wet rooms.
-
This device is not intended for use by persons (including children) with restricted physical, sensory or mental capabilities and/or by persons lacking the required understanding of the equipment and how it is used, unless they are supervised by a person who is responsible for their safety or they are given instructions on how to use the device.
-
Do not use on babies and small children.
-
Children should be supervised to ensure that they do not use the device as a toy.
-
This device is not intended for use on changing units, cots or similar.
-
Do not use it on persons sensitive to heat. The sensitivity to heat can be reduced or increased in the following cases:
– diabetic patients
– persons with sleepiness, dementia or difficulties concentrating
– persons with illness-related skin changes or persons with scarred skin areas in the application area
– persons with allergies
– children and older persons
– after consuming medications or alcohol -
Do not operate the device if you are wearing an implant, particularly if it is located in the area of the body to be treated. If you have any doubts, consult your doctor.
-
If you are pregnant, do not operate the device near your abdomen, in order to prevent this area from overheating. If you have any doubts, consult your doctor.
-
In case of acutely inflammatory processes, radiation should only be carried out after consulting a doctor.
-
Always limit the period of use and check the reaction of the skin.
-
Medications, cosmetics or food can lead to a over-sensitive or allergic reaction of the skin under certain conditions. Radiation must be ended immediately in this case.
-
An appropriate distance between the infrared lamp and the desired treatment area must be maintained during treatment so that no skin irritation, such as tingling, itching, burning or too high heat sensitivity occurs. Stop the treatment if this occurs. Alternatively, increase the radiation distance and/or reduce the radiation duration.
-
This device is not intended for radiation from above.
-
The minimum distances described in these instructions for use must be adhered to.
-
If the appliance is operated continuously, caution and attention are advisable – never fall asleep during radiation!
-
Prolonged use can cause burns to the skin.
-
Do not touch the infrared lamp or unscrew it when it is connected to the mains.
-
Children do not understand the risks associated with electrical appliances. Make sure the appliance is not used by children without appropriate supervision.
-
The appliance may be used only under supervision.
-
Keep children away from packaging materials (risk of suffocation).
-
Do not cover up or pack away the unit while it is warm.
-
Always remove the mains plug and let the unit cool off before you touch it.
-
Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the unit. The unit must be operated only when it is completely dry.
-
Protect the unit from strong impacts.
-
Do not pull the mains plug from the socket by the cord.
-
In the event of a defect or malfunction, switch the device off immediately and disconnect it from the power supply.
If the power cord of the device is damaged, it must be replaced by the manufacturer or an authorised customer service technician in order to avoid hazard. -
Disconnection from the mains supply is only guaranteed if the mains plug has been removed from the socket.
-
There is a risk of strangulation for babies and children who become trapped in the mains cable.
General notes
Important
- Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious injuries. Failure to observe this regulation shall void the warranty.
- If you need to have the unit repaired, contact customer service or an authorised dealer.
4. Initial use
Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use, check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
- Ensure that there is a socket near the place where the lamp will stand.
- Lay the mains cable in such a way that no one can trip over it.
5. Operation
-
Switching on the lamp
- Push the plug completely into the mains socket.
-
Enjoying the light
The recommended duration of treatment is maximum 12 minutes. We recommend selecting a shorter radiation period to start with. However, the skin of some people may show an over-sensitive (e.g. with extreme redness, blistering, itching, heavy sweating) or allergic reaction to heat radiation, even when the lamp is used correctly. If symptoms are not relieved after 6 to 8 applications, stop using the device and consult your doctor. -
Important instructions
The distance between the infrared lamp and the radiated part of the body should not be less than the following:
SIL 06: at least 24 in (60 cm)
SIL 16: at least 32 in (80 cm)
Always use the protective eyewear supplied during usage. The protective eyewear corresponds to the requirements of EN 171:2002 and serves to protect the eyes.
CAUTION: Never look directly into the infrared light without protective eyewear.
Basically,
examine the radiated section of the body regularly. Discontinue radiation immediately if any signs of an over-sensitive or allergic reaction appear and consult a physician. -
Switching off the lamp
- Pull the mains plug from the socket.
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it away and/or pack it up! Please note that the mains cable must not be wound round the infrared lamp either for storage or when in use.
- Pull the mains plug from the socket.
6. Changing the infrared lamp
The device must be switched off and allowed to cool and the mains plug pulled out before cleaning and changing the infrared heat lamp.
Please note that only infrared lamps of the original type may be used as replacements.
Warning
- Do not touch the infrared lamp or unscrew it when it is connected to the mains.
- Unplug the device, to avoid the risk of electrocution.
- In the interest of environmental protection, do not dispose of the device in household waste.
7. Cleaning and care of the unit
The unit should be cleaned occasionally.
Important
To avoid odours caused by fluff and dust, we recommend regularly cleaning the device as follows:
- The device must be switched off and allowed to cool and the mains plug pulled out before cleaning and changing the infrared heat lamp.
- Ensure that no water penetrates inside the unit!
- Do not wash the unit in a washing machine! Clean using a damp cloth, to which you can apply a little detergent if necessary.
- Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the unit. The unit must be operated only when it is completely dry.
- Do not use abrasive detergents and never immerse the unit in water.
8. Disposal
In the interest of protecting the environment, the unit must not be thrown out with the household waste at the end of its service life. Dispose of the unit at a suitable local collection or recycling point.
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.
9. Technical specifications
The serial number is located on the device or in the battery compartment.
Subject to technical modifications. This device meets the requirements of the European Medical Devices Directive 93/42/EEC with amendments as well as the German Medical Devices Act.
Hans Dinslage GmbH, Riedlinger Straße 28, 88524 Uttenweiler, Germany
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>