272804A Resideo Electric Heating Thermostats Installation Guide
- June 7, 2024
- resideo
Table of Contents
272804A Resideo Electric Heating Thermostats
SECURITY FEATURES
Locking Cover, Fig. 1
- Remove cover by swinging up from the bottom.
- Insert Tinnerman Speed Nut® supplied into slot at upper and lower rear of thermostat base.
- Drive Allen screws into Speed Nuts until head is flush with lower edge of Thermostat base.
- Re-install cover and lock by backing out Allen screws until screw body protrudes through cover hole.
- To unlock cover, drive Allen screws into thermostat base until screws body clears cover.
INSTALLATION INSTRUCTIONS
Range Stops, Fig. 2
-
Set thermostat to desired set point.
Remove cover. -
Install plastic dowels supplied into minimum and/or maximum range stop holes on inside back of cover.
-
Re-install cover. Check operation of range stops.
Resideo Technologies, Inc.
1985 Douglas Drive North, Golden Valley, MN 55422
1-800-468-1502
95C-10708—02
www.resideo.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>