RunCam Mini FPV DVR User Manual

Table of Contents

RunCam Mini FPV DVR

Red LED	Constantly on — Power status light
Blue LED	Constantly on — In standby mode
Blue LED	Blink slowly (1 time per second) — In recording mode
Blue LED	Blink quickly (2 times per second) — Micro SD is full or

failed to be recognized

RunCam-Mini-FPV-DVR-Overview

Recording with flight controller Remote Control.
It is advised to make the setup by Speedy Bee APP.
(Micro SD Card should be inserted in first).
In standby mode, short press the button to start recording.
In standby mode, long press the button, about 5 seconds, till the blue LED is off, the SD card will be formatted and recording will start.

In recording mode, short press the button, file will be saved and DVR will turn to standby mode.

In standby mode, long press the button for 5 seconds, the SD card will be formatted and recording will start.

Recording files will be saved automatically by segment per each 5 minutes and recording stops when Micro SD card is full.
It takes about 2G capacity for 1 hour recording. Thus an 8G Micro SD card can record about 3.5 hours.
DVR won’t save the file automatically after power off. So please stop recording before power off. Otherwise, you will miss your last recording

Select your Flight Controller and RunCam DVR-S.
Select the Associate pin, and then connect the PIN you selected to the H/L pad of the RunCam DVR-S
Select Associate mode, we can choose any mode. For example, if you want to start recording after the drone is arming, stop recording after disarming, you can select ARM mode.
Associate action, when the associated mode is activated,
RunCam DVR-S will perform this action. In general, this setting does not need to be changed.
Click Bind and Reboot

Open the App (iOS ≥ 1.0.8, Android ≥ 1.0.7)= > select the Help Center=>click RunCam DVR-S =》select telemetry control

Select your Flight Controller and RunCam DVR-S
Select the Associate pin, and then connect the PIN you selected to the H/L pad of the RunCam DVR-S.
Select Associate mode, we can choose any mode. For example, if you want to start recording after the drone is arming, stop recording after disarming, you can select ARM mode.
Associate action, when the associated mode is actives, RunCam DVR-S will perform this action. In general, this setting does not need to be changed.
Click Generate CLI Commands
Copy the commands and enter the commands on the CLI interface of ground station.