ULINE H-8512 Work Stool Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-8512 Work Stool Installation Guide
PARTS
ASSEMBLY
-
Insert glides into legs of five-star base. Turn base upright. Insert gas lift into center of base. Slide footring onto gas lift and tighten knob to secure. Slide dust cover onto gas lift over footring. (See Figure 1)
-
Use backrest and backrest mounting kit to assemble. Align plastic holder, post and steel plate to backrest. Use Allen wrench to tighten with supplied screws. Place cover over assembly. (See Figure 2)
-
Align mechanism with holes on bottom of seat. Use four seat screws to attach. (See Figure 3)
NOTE : Use Allen wrench to tighten screws.
-
Place plastic cover over socket on mechanism and slide assembled backrest post through plastic cover and into socket. Insert plastic stopper and tighten knob to secure. (See Figure 4)
-
Slowly lower stool assembly onto the gas lift. Press down on seat to secure.
ADJUSTMENTS
- Seat/Back Tilt – To tilt the seat and back, lift the lever. The seat and back tilt simultaneously at the same rate.
- Seat Height Adjustment – To raise seat height, lift lever up with little to no weight on the seat. To lower seat height, lift lever up while sitting.
- Footring Height – To adjust footring height, loosen knob and slide the footring up or down. Set footring at preferred height and tighten knob to secure.
- Back Height – To adjust back height, loosen knob and slide the back up or down. Set back at preferred height and tighten knob to secure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>