ULINE Pipe Clothing Rack Single Rail Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE Pipe Clothing Rack Single Rail
TOOLS INCLUDED
Allen Wrench
|
Wrench
---|---
PARTS
Caster x 4
|
Adjustable Connector x 2
|
Set Screw x 2
---|---|---
Locking Washer x 4
|
Flat Washer x 4
|
Top Upright x 2
Bottom Upright x 2
|
Hangbar x 1
|
Base x 1
ASSEMBLY
-
Screw the four casters with flat washers and locking washers into the base using provided wrench. (See Figure 1)
-
Thread each bottom upright into the base. (See Figure 2) To fully secure uprights, place included wrench into pipe slots and tighten fully. (See Figure 2a)
NOTE: Ends with slots should be facing up.
-
Screw an adjustable connector to the top of each bottom upright. Make sure connectors are facing out. (See Figure 3)
-
Tighten set screws using Allen wrench to lock adjustable connectors in place. (See Figure 4)
-
Twist each top upright into hangbar. (See Figure 5)
NOTE: Ends with slots should be facing down.
-
Loosen adjustable connectors and insert hangbar with top uprights from step 5. Drop to desired height and lock into position by retightening connectors. (See Figure 6)