Shenzhen W1S TWS Smart Bluetooth Headset Earbuds User Manual
- June 5, 2024
- Shenzhen
Table of Contents
Shenzhen W1S TWS Smart Bluetooth Headset Earbuds User Manual
Charging
Use a 5V 500mA adapter to charge the charging cabin.
The charging cabin will automatically charge the earbuds once they are
properly placed in the cabin.
Warning: (Do not place wet earbuds in the charging cabin)
Earbuds Pairing
- The earbuds will automatically power on when removed from the charging cabin, and will flash in alternating red and blue light to start auto pairing. The left and right earbuds will automatically pair with each other.
- Turn on your phone’s Bluetooth and search for nearby devices. The earbuds’ Bluetooth name is “Earbuds”, tap to connect the earbuds.
Touch Control
Product Parameters
- Earbuds Talk Time:
- Wireless Connection : Bluetooth 5.1
- Communication Distance : Approximately 10m (in unobstructed open areas)
- Bluetooth Protocol : HSP/HFP/A2DP/AVRCP
- Battery Type : Lithium-ion polymer battery
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or modifications not expressly approved by the party.
Responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>