ULINE Lids For Dumping Hoppers Installation Guide
- June 7, 2024
- ULINE
Table of Contents
**ULINE Lids For Dumping Hoppers Installation Guide
**
TOOLS NEEDED
-
Pliers
-
Tin Snips
-
1/2″ Wrench
-
Power Drill
-
3/8″ Drill Bit
PARTS
-
Bolt x 8
-
Locknut x 8
-
Hinge/Lock Bar x 2
-
Right Bracket x 2
-
Left Bracket x 2
-
Cotter Pin x 2
-
Lid (2 pieces for H-3508 and H-3509)
SAFETY
WARNING! Ensure that all employees understand and follow these instructions. Failure to read and understand these instructions before installing the lid can result in serious injury.
SAFETY INSTRUCTIONS
- ALL contents must be removed from the hopper before any work is performed on the hopper.
- Ensure that all information, safety and warning labels stay in place and remain legible.
- Maintenance and repairs should be done only by personnel qualified to perform the required work.
ASSEMBLY
INSTALLING REAR HINGE BRACKETS
- Line up one right bracket with the rear right side of hopper **(See Figure 1)
**
- Mark centers of the two holes in the bottom of the Remove bracket and drill two 3/8″ holes into the hopper lip.
- Place bracket back on hopper and line up
- Secure bracket to hopper lip using 2 bolts and 2 lock **(See Figure 2)
**
-
Repeat steps 1-4 with one left bracket on the rear left side of the
INSTALLING FRONT LOCK BAR BRACKETS
NOTE: Front lock bar brackets only need to be installed if you are going to be using the lock bar to lock the lid -
Measure 6″ back from the front right side of the **(See Figure 3)
**
- Repeat steps 2-4 to install one right bracket.
- Repeat steps 6-7 with one left bracket on the front left side of the hopper. (See ****Figure 4)
INSTALLING THE LID
- The shape of the lid should allow it to fit inside all 4 brackets, but it might be necessary to cut small notches out of the lid for it to fit ****(See Figure 5)
** NOTE:** In hoppers with two-piece design, there will be a right and left lid.
- Insert hinge bar through all lid hinge **(See Figure 6)
**
- Slide hinge bar into bottom hole of right hinge **(See Figure 7)
**
- On the opposite side, push stop pin away from left hinge **(See Figure 8)
**
- When pin clears bracket, push pin down and align hinge bar in bracket hole. Let hinge bar slide into bottom bracket **(See Figure 9)
**
- Insert cotter pin through hinge bar hole near the right hinge bracket. **(See Figure 10)
**
- Follow steps 10-13 to install the lock bar, except lock bar goes into the top hole of bracket. **(See Figure 11)
**
- Insert cotter pin (or padlock, not included) to secure lock **(See Figure 12)
**
- Lock bars can also be used as a lid prop by inserting the stop pin into the lock bar bracket **(See Figure 13)
Contact Us
Phone: 1-800-295-5510
Web: uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>