ULINE Cubitainers Instructions
- June 7, 2024
- ULINE
Table of Contents
S-18116 ,S-18117
CUBITAINERS®
1-800-295-5510
uline.com
INSTRUCTIONS
NOTIFICATION FOR ULINE UN/DOT PACKAGING FOR HAZARDOUS SOLIDS/LIQUIDS
Please note that under the U.S. Department of Transportation’s Title 49CFR,
Section 173.22, it is the Shipper’s Responsibility to ensure that an
authorized package has been selected for the product they intend to offer for
transportation and that the selected package is properly closed for
transportation in accordance with the manufacturer’s notification.
Please do any and all testing and research necessary to ensure you have
selected the proper container for use with your product.
To meet UN/DOT Standards, this package must be properly closed for shipment.
Closing instructions have been included below. Failure to follow the closure
instructions will render the UN/DOT Certification invalid.
The use of non-specified components will lead to nonconformance with DOT
marks. If you are not the final assembler, you are required to transfer this
information to the party who will complete the assembly of this package in
accordance with 49 CFR para. 178.2.
In accordance with the U.S. Department of Transportation’s Title 49CFR,
Section 178.2, manufacturers of U.N. Standard/ DOT Specification packages are
required to notify in writing each person to whom that packaging is
transferred of all requirements in this part not met at the time of transfer,
and with information specifying the type(s) and dimensions of the closures,
including gaskets and any other components needed to ensure that the packaging
is capable of successfully passing the applicable performance tests. This
information must include any procedures to be followed, including closure
instructions for inner packaging and receptacles, to effectively assemble and
close the packaging for the purpose of preventing leakage in transportation.
CLOSING INSTRUCTIONS
- Place 38400 mm copolymer polypropylene screw cap with polyethylene foam liner cover (included) on the mouth of the container.
- Tighten screw cap using a torque application of 25 in-lbs.
- After the screw cap is tightened, the dust cover must be taped in place with 2″ wide tape. Extend tape at least 2″ down each side panel.
CAUTION! The assembled Cubitainer®is not authorized for air transport of hazardous materials.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>