ULINE H-6067 Bulk Soap Dispensers Installation Guide

H-6067
BULK SOAP DISPENSER
1-800-295-5510

INSTALLATION

OPENING THE DISPENSER

1. To open the dispenser lid, push in the button on the bottom of the back of the dispenser.
2. Back lid will pop off. (See Figure 1)

GENERAL MOUNTING INSTRUCTIONS

• Use the included tape on glazed tile, painted metal or unpainted metal walls. Tape will not work well if wall surface is porous, like brick or wood.
• On all other wall surfaces, use screws and anchors (included) or other appropriate hardware based on surface type.
• Install dispenser above a sink or counter. Never install where spillage can fall on floor creating hazardous conditions.
• Installer will be held responsible for proper installation.
• To be in compliance with ADA regulations, the dispenser should be mounted no more than 48″ from the ground.

MOUNTING WITH DOUBLE-SIDED TAPE

1. Thoroughly clean wall surface and let dry completely. For silicone buildup, use a pumice-type cleaner or grout cleaner to clean the surface. 2. Peel off paper from back of tape (included). Press dispenser firmly to wall and hold for at least 30 seconds to make sure tape has completely adhered to wall. (See Figure 2)
2. Wait 24 hours before filling with soap to ensure that the tape has completely adhered to wall.

MOUNTING WITH SCREWS AND ANCHORS

1. Remove lid. Push down on back plate and detach dispenser from back plate. (See Figure 3)
2. Using the back plate as a template, mark hole locations on wall.
3. Drill 3/16″ diameter holes for anchors and screws or other hardware. Attach dispenser to back plate and replace lid.

FILLING

FILLING INSTRUCTIONS
CAUTION! For dispenser to work properly, use liquid soap only.

1. Remove lid.
2. Fill with appropriate soap and replace lid.
3. Priming the dispenser will take 6-10 strokes.

DISCLAIMER:

Inappropriate soap use may result in ineffective dispenser operation or clogging. Soap containing any type of scrubbers will cause the dispenser to leak or eventually fail.

MAINTENANCE

MAINTENANCE INSTRUCTIONS

It is important to clean and maintain dispenser on a regular, scheduled basis. Failure to do so can result in dispenser malfunction.

• Open dispenser. Flush tank and pump mechanism with warm water to remove residue and contaminates. Refill with new soap and replace lid. (See Figure 4)
• Cleaning all touch-points on dispenser with a disinfectant should be part of a regular cleaning schedule. (See Figure 5)
• Periodically give the dispenser an overall cleaning. All internal and external parts should be cleaned thoroughly.

CAUTION! Never use abrasive cleaners when cleaning soap dispensers.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>