ACU-RITE 5-in-1 Sensor Bearing Kit 5N1DSSA Instruction Manual

ACU-RITE 5-in-1 Sensor Bearing Kit 5N1DSSA Instruction Manual

The dual solar sub assembly for the 5-in-1 sensor optimizes the sensor’s sun

1. Remove the screw from just below the exposure, allowing the sensor’s solar- powered aspirating fan to run more often. wind cups. Keep the screw for The sensor’s internal fan helps to ensure accurate temperature measurement

Your AcuRite 5-in-1 sensor features a modular design that allows for the 2. Spray a very small amount of lubricant replacement of certain assemblies. Please take care when handling the 5-in-1 into the hole.  sensor components – the electronic components inside are sensitive.

NOTE: you will need to remove your existing 5-in-1 sensor from its mounting then right side up several times. location to install the dual solar sub assembly

Scan QR Code to View a Video!

http://www.acurite.com/kbase/5N1DSSA_Sensor_Part.html?utm_source=5n1dssa&utm_medium=qrcode&utm_campaign=Instructions

TO LUBRICATE:

1. Remove the screw from just below the wind cups. Keep the screw for  re-insertion at completion
2. Spray a very small amount of lubricant  into the hole
3. Tip the 5-in-1 Sensor upside down so that the wind cups are on the bottom then right side up several times. location to install the dual solar sub assembly
4. Re-insert the screw into hole.

NEW BEARING ASSEMBLY INSTALLATION

NOTE: Remove batteries from sensor to erroneous rainfall or wind readings when handling and transporting sensor.

REMOVE 4 SCREWS
  

1. Remove four LONG screws and separate upper white portion and lower gray portions of the sensor. Keep the screws for re-assembly.

2. . Set aside the lower gray portion for reassembly later.
   

3. Turn the upper white portion over and remove the 4 SHORT screws near the fan assembly. Keep the screws  for reassembly.
   

4. Gently remove the old upper wind speed  and solar assembly from rain housing and discard.
   

5. . Place new wind speed/solar assembly and line up the screw holes with the upper rain housing
   

6. Turn the upper white portion over and re-install the 4  SHORT screws and tighten by hand.
   

7. Reinstall four LONG screws to join the upper white portions and lower gray portions of the sensor
   

ww.AcuRite.com

References

• AcuRite Weather Monitoring | #1 Weather Station Brand in North America

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>