retrospec B096WVBBYW Chipmunk Kick Scooter Owner’s Manual
- June 7, 2024
- retrospec
Table of Contents
retrospec B096WVBBYW Chipmunk Kick Scooter
AN IMPORTANT MESSAGE TO PARENTS
This manual contains extremely important safety information. For your child’s
safety, it is your responsibility to completely review this information with
your child and make sure you instruct your
child to follow all warnings, cautions, instructions and safety topics so that
all riders are able to safely and responsibly use this scooter. All children
and preteens should ride with adult supervision at
all times. Retrospec recommends that you periodically review and reinforce all
the information in this manual with all riders, and that you inspect and
maintain your scooter to insure their safety.
GENERAL WARNING
Riding a scooter can be a dangerous activity. Certain conditions may cause
components to fail without fault of the manufacturer. Scooters can, and are
intended to move, and it is therefore possible to
lose control, fall off and/or get into dangerous situations that no amount of
care, instruction or expertise can eliminate. If such a thing does occur you
can become seriously injured or die.
LIKE ANY OTHER MOVING PRODUCT, USING A SCOOTER CAN BE A DANGEROUS ACTIVITY AND
MAY RESULT IN INJURY OR DEATH EVEN WHEN USED WITH PROPER SAFETY PRECAUTIONS.
USE AT YOUR OWN RISK AND USE COMMON SENSE.
- Ages 3+ only.
- Do not exceed weight limit indicated on the package: Max rider weight 99 lbs / 45kgs.
- Rider weight does not necessarily mean a child’s size is appropriate to fit or maintain control on this scooter.
- Read and understand the enclosed owner’s manual and all other literature before riding this product.
- Always wear safety equipment, such as helmet, knee pads, and elbow pads when riding your scooter and keep helmet’s chinstrap securely buckled. Always wear closed-toe shoes.
- Ride on smooth , paved surfaces away from motor vehicles.
- Avoid sharp bumps, drainage grates, and sudden surface changes which could cause scooter to suddenly stop.
- Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking, and visibility.
- Do not ride at night.
- Avoid excessive speed associated with downhill rides.
- Obey all local traffic and scooter riding laws and regulations.
- Check local laws and regulations.
- Watch out for pedestrians.
- Check and secure all fasteners before every ride.
- Replace all worn and broken parts immediately.
- To help reduce the risk of injury, adult supervision is required.
- A parent’s decision to allow his or her child to ride this product should be based on the child’s skill, maturity, and ability.
- Watch out for obstacles that could catch your wheel or force you to turn suddenly or lose control.
- Be careful to avoid pedestrians, other wheeled products (such as skaters, skateboarders, scooters, bikes, etc.) and children or animals that may enter your path.
- Never use in roadways, near motor vehicles, or on or near steep inclines or steps, swimming pools or other bodies of water.
- Always wear protective gear including helmet, wrist guards, elbow and knee pads.
- CHOKING HAZARD – Small parts, not for children under 3 years of age.
ASSEMBLY INSTRUCTIONS
ASSEMBLY – Handlebar/Steering Mast
While pressing Red Locking Button, insert Handlebar/steering Mast into scooter
Body/deck Mounting Hole – flat side facing rider/Retrospec logo facing
forward. Insert Mast until you hear a click indicating the mast is locked into
the scooter body. Some force may be required.
DISASSEMBLY – Transport/Storage
Reverse procedure. Locate Red Locking Button on side of the scooter behind
front wheels. Press Red Locking Button while pulling Mast with other hand.
Watch-out for those near you – keep them away. Some force may be required as
Mast is held securely in place for safe riding.
ADJUSTMENT
- Open handlebar Quick Release Lever by pulling it away from the handlebar assembly.
- Slide T-Bar upwards to one of the three Lock-Button hole positions. Make sure Lock-Button fully engages into the desired Lock-Hole.
- Lock close the Quick-Release Lever tightly against the handlebar assembly.
The lever should begin to offer resistance at about the half-way point in its travel. The lever should require some force to close. If it closes too easily, or if the effort to close the clamp is too great, adjust the clamping force by loosening or tightening the adjusting nut on the opposite side of the lever.
RIDING
Grasp the grips with both hands. Place one foot on the deck and push with the
other foot. Once you are moving, position both feet on the deck approximately
at 45⁰ angle to direction of travel.
To turn, lean in the direction you would like to go. Lean right to turn right,
lean left to turn left.
BRAKING
Step onto the foot brake over the rear wheel to slow or stop. It is
recommended you practice applying the brake at various speeds and in an open,
flat area free from obstructions. Attention: The brake plate/rear wheel fender
can become very hot.
Do not attempt stunts, tricks, jumps, grinds, or riding backwards – it is not designed for stunt riding and such riding risks losing control of the scooter.
MAINTENANCE
With time, the wheels will wear down or can become damaged, especially when used on rough surfaces. The rear wheel(s), where the brake applies pressure, can be particularly affected. Check your wheels regularly for signs of wear. Replace if necessary. Retrospec recommends you use a qualified repair facility.
CARE
Clean, wipe with a damp cloth. Do not use industrial cleaners, solvents, alcohol or ammonia-based cleaners – they may damage surfaces and plastic parts. Get in the habit of inspecting your scooter on a regular basis and before every ride.
RETROSPEC LIMITED WARRANTY
The manufacturer warrants this product to be free of manufacturing defects for
a period of 90 days from the date of purchase. This Limited Warranty does not
cover normal wear and tear, or any damage, failure or loss caused by improper
assembly, maintenance, or storage.
This Limited Warranty will be void if the product is ever used in a manner
other than for recreation, modified in any way, or used as a rental.
Retrospec does not offer an extended warranty. If you have purchased an
extended warranty, it must be honored by the store at which it was purchased.
The manufacturer is not liable for incidental or consequential loss or damage
due directly or indirectly to the use of this product. For your records, save
your original sales receipt with this manual.
RIDE AT YOUR OWN RISK AND WITH APPROPRIATE AND SERIOUS ATTENTION TO SAFE
OPERATION. USE CAUTION AND COMMON SENSE.
TEAM@RETROSPEC.COM
RETROSPEC.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>